4 April 2012 in ISRN Renewable Energy
Wind and solar energies are the alternative energy sources that can be used to supplement the conventional energy sources particularly in Bangladesh. In this work, the aim is to assess the current wind and solar energy potential in Bangladesh. The wind data for the five stations obtained from Local Government Engineering Department have been assessed, but only two of them seem to be eligible for energy production. Annual average, monthly average, and hourly average wind speeds and wind power densities were calculated from the wind data. The Weibull distribution parameters (c and k), the dominant wind directions, and the frequency distributions were also determined. Experimentally measured solar radiation data are not available over Bangladesh. Measured climatological data such as cloud cover and sunshine duration data of Bangladesh Meteorological Department from 1992 to 2001 used for the estimation of global solar radiation as they are correlated. Technoeconomic feasibility analysis is done for 100 kW grid connected wind and solar photovoltaic (PV) systems. Renewable-energy-based system will bring more environmental benefits than conventional power in terms of human health, reduction of air pollution, and decrease of noise, and so forth. However, in the above estimation, these were not considered.
26 April 2023 in Journal of Vacuum Science & Technology B
The photo-induced triboelectric nanogenerator (PTENG) has been explored as new generation energy technology, which is enabled by coupling triboelectric and photo-induced charge carriers. PTENG shows a dual work mechanism that is attributed to the synergetic outcome of the photovoltaic and triboelectric effects. This study aims to provide a new strategy for triboelectric nanogenerator devices to achieve high output performance for various smart electronic device applications. Aluminum and n-type silicon were chosen as two different materials for triboelectric measurements. Different techniques were adopted to obtain triboelectric output parameters through the in-house developed triboelectric setup. AFM and Kelvin probe force microscopy imaging techniques were employed to obtain surface roughness and to measure the change in surface potential under the illumination of red (630 nm) laser light. A significant improvement in surface potential of around 40 mV was observed under laser illumination. Triboelectric characterization has been performed to obtain open circuit voltage (VOC) and short circuit current (ISC) with and without light illumination at different speeds of the motor. VOC and Isc were found to be 0.8 V and 2.2 nA, respectively, at 50 rpm speed without any illumination, which was further enhanced to 1.8 V and 5.5 nA, respectively, under the influence of laser light illumination. An increase in the motor speed to 100 rpm results in higher VOC (2.4 V) and higher ISC (3.4 nA) as compared to 50 rpm at no illuminating condition. However, it enhances to 3.4 V and 6.0 nA in illuminating conditions. This is attributed to the generation of charge carrier due to triboelectrification, which is further enhanced because of the photovoltaic effect wherein the generation of electron-hole pair occurs due to the shining of light on the side of semiconductors. These synergetic effects have tremendous potential in sustainable energy harvesting.