The impact of threading dislocation density on the leakage current of reverse current-voltage (I–V) characteristics in Schottky barrier diodes (SBDs), junction barrier Schottky diodes, and p-n junction diodes (PNDs) was investigated. The leakage current density and threading dislocation density have different positive correlations in each type of diode. Consequently, the correlation in SBDs is strong but weak in PNDs. Nano-scale inverted cone pits were observed at the Schottky junction interface, and it was found that leakage current increases in these diodes due to the concentration of electric fields at the peaks of the pits. The threading dislocations were found to be in the same location as the current leakage points in the SBDs but not in the PNDs.
The nano-scale pits above the threading dislocations were found to be in the same location as the leakage current points in Schottky barrier diodes and junction barrier Schottky diodes. This study compared the leakage current of 1.2 kV, 200 A diodes with and without nano-scale pits. The leakage current in diodes without nano-scale pits was lower than those in diodes with pits. In the diodes without nano-scale pits, the leakage currents were generated at step-bunching area and the leakage current at the threading dislocations was not observed.
Anisotropic magnetoresistance (AMR) effects in Cox(MnyGa1-y)100-x Heusler alloy thin films epitaxially grown on a MgO single-crystal substrate have been investigated by changing their composition in the ranges of x =44.4–59.2 at. % and y =0.44–0.55. Negative AMR ratios were observed at measurement temperatures from 5 to 300 K for all the films, indicating that Co2MnGa films have possible half-metallicity. The AMR ratio changed sensitively depending on the composition of the films. In the case of the film with y =0.44, the AMR ratio peaked at around x =50 at. %. In addition, the amplitude of the AMR ratio increased with decreasing y when x was approximately 50 at. %. As a notable result, large negative AMR ratios of −2.32% at 5 K and −0.82% at 300 K, whose amplitude is more than four times that of Co2MnSi films, were obtained for the Co−Mn−Ga films. These results suggest that the Co2MnGa films have a high spin polarization due to half-metallicity.
The authors have demonstrated highly collimated electron-beam emission from a practical electron gun with a single-atom electron source; of the total emission current entered the electron optics. This ratio was two or three orders of magnitude higher than those of the conventional electron sources such as a cold field emission gun and a Schottky gun. At the pressure of less than , the authors observed stable emission of , which generates the specimen current of required for scanning electron microscopes.