Takao Tabei

Takao Tabei

Auto-generated profile, based on publicly available information

Takao Tabei

Faculty of Science, Kochi University, Kochi, Japan

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 1999 in Geophysical Research Letters
Verified
Journal Article
Open access
PDF file
TOTaku Ozawa
Taku Ozawa
TTTakao Tabei
Takao Tabei
SMShin‐Ichi Miyazaki
Shin‐Ichi Miyazaki

1 November 2002 in Earth, Planets and Space
Verified
Journal Article
Open access
PDF file
TTTakao Tabei
Takao Tabei
MHManabu Hashimoto
Manabu Hashimoto
SMShin’iChi Miyazaki
Shin’iChi Miyazaki
KHKazuro Hirahara
Kazuro Hirahara
FKFumiaki Kimata
Fumiaki Kimata
TKTeruyuki Kato
Teruyuki Kato
The Median Tectonic Line (MTL) is the longest arc-parallel fault system in southwest Japan whose right-lateral strike-slip is related to oblique subduction of the Philippine Sea plate (PH). We constructed a dense Global Positioning System network along a 200 km-long traverse line across the MTL in 1998 to estimate deep fault structure and slip distribution. Horizontal velocities were determined at 65 sites through campaign measurements and show crustal shortening in the direction of the plate convergence. Using multi-rectangular segments and depth-dependent coupling at the plate interface, we calculate and remove elastic deformation caused by the PH subduction. The residual velocity field shows right-lateral strike-slip block motion of about 5 mm/yr across the MTL, consistent with geological estimates. However, the block boundary does not coincide with the surface trace of the MTL, being displaced 20–30 km to the north. The residual velocity field is reproduced by a model with a 35–45° northwarddipping fault plane, full locking of the upper portion to a depth of 15 km, and steady slip of 5 mm/yr below. GPS results are supported by imaging of an inclined fault plane revealed by seismic profiling and currently low activity of shallow earthquakes.

1 October 2003 in Earth, Planets and Space
Verified
Journal Article
Open access
PDF file
TTTakao Tabei
Takao Tabei
MHManabu Hashimoto
Manabu Hashimoto
SMShin’ichi Miyazaki
Shin’ichi Miyazaki
YOYusaku Ohta
Yusaku Ohta
We estimate long-term/permanent crustal deformation in the Nankai forearc, southwest Japan, that accumulated over one earthquake deformation cycle in the Nankai subduction zone. A short-term deformation due to an oblique subduction of the Philippine Sea plate is modeled based on coseismic fault slips associated with interplate thrust earthquakes at the Nankai Trough, and subtracted from the interseismic crustal velocity field observed by GPS. The long-term/permanent deformation left in the data shows arc-parallel movement of the forearc at a rate of 5— 10 mm/yr. We interpret that the forearc movement, driven by the oblique plate convergence, is accommodated by steady aseismic slip on the deep portion of the fault plane of the Median Tectonic Line (MTL) on the rear boundary of the Nankai forearc. The rate of the forearc movement is consistent with the geological slip rate of the MTL in the late Quaternary, and also with that expected from deflection of the slip vector of the 1946 Nankai earthquake from the current plate convergence vector.

19 July 2018 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
CPCecep Pratama
Cecep Pratama
TITakeo Ito
Takeo Ito
TTTakao Tabei
Takao Tabei
FKFumiaki Kimata
Fumiaki Kimata
EGEndra Gunawan
Endra Gunawan
IMIrwan Meilano
Irwan Meilano
Lack of observation network in the vicinity of oceanic intraplate earthquake lead the estimation of coseismic fault slip with high uncertainty. Satriano et al. [2] and Wei et al. [3] found NNE trending left-lateral slip as the primary features. In another hand, Yue et al. [4] and Hill et al. [5] proposed WNW trending right-lateral faults structure as the main characteristic. Here, we investigate the coseismic fault model that could explain the coseismic offset both vertical and horizontal in a 3-D heterogeneous earth structure. We constructed finite element model that include three-dimensional velocity structure, topography/bathymetry, spherical-earth and subducting slab. In this study, we employed scaling slip to adjust slip amount and total seismic moment. Instead of original slip amount, we preserve seismic moment as a basis comparison. Based on vertical and horizontal observation data, WNW trending right-lateral fault could fit better than NNE trending left-lateral fault. The present study demonstrates best-fit calculation using scaling slip optimized to the horizontal or vertical observation lead the both fault model worsen the misfit of vertical or horizontal component, respectively. This result analysis indicates a trade-off between vertical and horizontal component and reflects the importance of revisiting the fault slip modeling incorporating vertical and horizontal data equally.