The direct conversion of CO2 to CH3OH represents an appealing strategy for the mitigation of anthropogenic CO2 emissions. Here, we report that small, narrowly distributed alloyed PdGa nanoparticles, prepared via surface organometallic chemistry from silica-supported GaIII isolated sites, selectively catalyze the hydrogenation of CO2 to CH3OH. At 230 °C and 25 bar, high activity (22.3 molMeOH molPd–1 h–1) and selectivity for CH3OH/DME (81%) are observed, while the corresponding silica-supported Pd nanoparticles show low activity and selectivity. X-ray absorption spectroscopy (XAS), IR, NMR, and scanning transmission electron microscopy–energy-dispersive X-ray provide evidence for alloying in the as-synthesized material. In situ XAS reveals that there is a dynamic dealloying/realloying process, through Ga redox, while operando diffuse reflectance infrared Fourier transform spectroscopy demonstrates that, while both methoxy and formate species are observed in reaction conditions, the relative concentrations are inversely proportional, as the chemical potential of the gas phase is modulated. High CH3OH selectivities, across a broad range of conversions, are observed, showing that CO formation is suppressed for this catalyst, in contrast to reported Pd catalysts.
Ni can be used as a catalyst for dry reforming of methane (DRM), replacing more expensive and less abundant noble metal catalysts (Pt, Pd, and Rh) with little sacrifice in activity. Ni catalysts deactivate quickly under realistic DRM conditions. Rare earth oxides such as CeO2, or as CeO2-ZrO2-Al2O3 (CZA), are supports that improve both the activity and stability of Ni DRM systems due to their redox activity. However, redox-active supports can also enhance the undesired reverse water gas shift (RWGS) reaction, reducing the hydrogen selectivity. In this work, Ni on CZA was coated with an ultrathin Al2O3 overlayer using atomic layer deposition (ALD) to study the effects of the overlayer on catalyst activity, stability, and H2/CO ratio. A low-conversion screening method revealed improved DRM activity and lower coking rate upon the addition of the Al2O3 ALD overcoat, and improvements were subsequently confirmed in a high-conversion reactor at long times onstream. The overcoated samples gave an H2/CO ratio of ∼1 at high conversion, much greater than uncoated catalysts, and no evidence of deactivation. Characterization of used (but still active) catalysts using several techniques suggests that active Ni is in formal oxidation state >0, Ni-Ce-Al is most likely present as a mixed oxide at the surface, and a nominal thickness of 0.5 nm for the Al2O3 overcoat is optimal.
30 October 2018 in The Journal of Physical Chemistry C