10 May 2021 in Nature Electronics
29 April 2020 in Physical Review Letters
Optomechanical systems in the well-resolved-sideband regime are ideal for studying a myriad of quantum phenomena with mechanical systems, including backaction-evading measurements, mechanical squeezing, and nonclassical states generation. For these experiments, the mechanical oscillator should be prepared in its ground state, i.e., exhibit negligible residual excess motion compared to its zero-point motion. This can be achieved using the radiation pressure of laser light in the cavity by selectively driving the lower motional sideband, leading to sideband cooling. To date, the preparation of sideband-resolved optical systems to their zero-point energy has eluded laser cooling because of strong optical absorption heating. The alternative method of passive cooling suffers from the same problem, as the requisite milliKelvin environment is incompatible with the strong optical driving needed by many quantum protocols. Here, we employ a highly sideband-resolved silicon optomechanical crystal in a buffer-gas environment at to demonstrate laser sideband cooling to a mean thermal phonon occupancy of quantum (self-calibrated using motional sideband asymmetry), which is of the oscillator’s zero-point energy and corresponds to 92% ground state probability. Achieving such low occupancy by laser cooling opens the door to a wide range of quantum-optomechanical experiments in the optical domain.
11 March 2022 in Nature Communications
Solid-state microwave systems offer strong interactions for fast quantum logic and sensing but photons at telecom wavelength are the ideal choice for high-density low-loss quantum interconnects. A general-purpose interface that can make use of single photon effects requires < 1 input noise quanta, which has remained elusive due to either low efficiency or pump induced heating. Here we demonstrate coherent electro-optic modulation on nanosecond-timescales with only $$0.1{6}_{-0.01}^{+0.02}$$ microwave input noise photons with a total bidirectional transduction efficiency of 8.7% (or up to 15% with $$0.4{1}_{-0.02}^{+0.02}$$ ), as required for near-term heralded quantum network protocols. The use of short and high-power optical pump pulses also enables near-unity cooperativity of the electro-optic interaction leading to an internal pure conversion efficiency of up to 99.5%. Together with the low mode occupancy this provides evidence for electro-optic laser cooling and vacuum amplification as predicted a decade ago.
7 May 2019 in Nature Communications
Quantum mechanics imposes a limit on the precision of a continuous position measurement of a harmonic oscillator, due to backaction arising from quantum fluctuations in the measurement field. This standard quantum limit can be surpassed by monitoring only one of the two non-commuting quadratures of the motion, known as backaction-evading measurement. This technique has not been implemented using optical interferometers to date. Here we demonstrate, in a cavity optomechanical system operating in the optical domain, a continuous two-tone backaction-evading measurement of a localized gigahertz-frequency mechanical mode of a photonic-crystal nanobeam cryogenically and optomechanically cooled close to the ground state. Employing quantum-limited optical heterodyne detection, we explicitly show the transition from conventional to backaction-evading measurement. We observe up to 0.67 dB (14%) reduction of total measurement noise, thereby demonstrating the viability of backaction-evading measurements in nanomechanical resonators for optical ultrasensitive measurements of motion and force.
11 February 2025 in Nature Physics
The rapid development of superconducting quantum hardware is expected to run into substantial restrictions on scalability because error correction in a cryogenic environment has stringent input–output requirements. Classical data centres rely on fibre-optic interconnects to remove similar networking bottlenecks. In the same spirit, ultracold electro-optic links have been proposed and used to generate qubit control signals, or to replace cryogenic readout electronics. So far, these approaches have suffered from either low efficiency, low bandwidth or additional noise. Here we realize radio-over-fibre qubit readout at millikelvin temperatures. We use one device to simultaneously perform upconversion and downconversion between microwave and optical frequencies and so do not require any active or passive cryogenic microwave equipment. We demonstrate all-optical single-shot readout in a circulator-free readout scheme. Importantly, we do not observe any direct radiation impact on the qubit state, despite the absence of shielding elements. This compatibility between superconducting circuits and telecom-wavelength light is not only a prerequisite to establish modular quantum networks, but it is also relevant for multiplexed readout of superconducting photon detectors and classical superconducting logic.