The properties of faba bean (Vicia faba L.) protein isolate (FPI) gels depend on their starting protein material and can be modulated by the addition of polysaccharides. In order to investigate the interplay between these two factors, commercial FPI (FPI1) and FPI prepared in-house (FPI2) were used to fabricate glucono-delta-lactone-induced gels, with or without dextran (DX) addition. FPI1 exhibited lower solubility in water and a larger mean particle size, likely because it experienced extensive degradation due to the intense conditions involved in its preparation. The FPI1 gel showed a similar water-holding capacity as the FPI2 gel; however, its hardness was lower and viscoelasticity was higher. After DX addition, the hardness of both FPI gels decreased, while their water-holding capacity increased. Interestingly, DX addition decreased the viscoelasticity of the FPI1 gel but enhanced the viscoelasticity of the FPI2 gel. The microstructural analysis demonstrated that the density of the aggregation network decreased in the FPI1 gel after DX addition but increased in the FPI2 gel. This was consistent with the changes observed in the dominant protein interaction forces in these gels after DX addition. Overall, these findings have the potential to guide ingredient selection for the tailored preparation of FPI gels.
Douchi is a traditional Chinese fermented soybean product, in which acetoin is a key flavor substance. Here, the α-acetolactate decarboxylase gene aldC was cloned from Lactiplantibacillus (L.) plantarum and overexpressed in Lactococcus (L.) lactis NZ9000 by nisin induction. The ALDC crude enzyme solution produced an enzyme activity of 35.16 mU. Next, whole cells of the recombinant strain NZ9000/pNZ8048-aldC were employed as the catalyst to produce acetoin in GM17 medium. An optimization experiment showed that an initial OD600 of 0.6, initial pH of 7.5, nisin concentration of 20 ng/mL, induction temperature of 37 °C and static induction for 8 h were the optimal induction conditions, generating the maximum acetoin production (106.93 mg/L). Finally, after incubation under the optimal induction conditions, NZ9000/pNZ8048-aldC was used for whole-cell biocatalytic acetoin production, using soybean as the substrate. The maximum acetoin yield was 79.43 mg/L. To our knowledge, this is the first study in which the aldC gene is overexpressed in L. lactis and whole cells of the recombinant L. lactis are used as a biocatalyst to produce acetoin in soybean. Thus, our study provides a theoretical basis for the preparation of fermented foods containing high levels of acetoin and the biosynthesis of acetoin in food materials.