David Miller

David Miller

Auto-generated profile, based on publicly available information

David Miller

Department of Physics, Material Science Institute, Center for Optical, Molecular, and Quantum Science, University of Oregon 1 , Eugene, Oregon 97403, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 October 2019 in Nature Communications
Verified
Journal Article
Open access
PDF file
ABAndrew Blaikie
Andrew Blaikie
DMDavid Miller
David Miller
BABenjamin Jose Aleman
Benjamin Jose Aleman
Bolometers are a powerful means of detecting light. Emerging applications demand that bolometers work at room temperature, while maintaining high speed and sensitivity, properties which are inherently limited by the heat capacity of the detector. To this end, graphene has generated interest, because it has the lowest mass per unit area of any material, while also possessing extreme thermal stability and an unmatched spectral absorbance. Yet, due to its weakly temperature-dependent electrical resistivity, graphene has failed to challenge the state-of-the-art at room temperature. Here, in a departure from conventional bolometry, we use a graphene nanoelectromechanical system to detect light via resonant sensing. In our approach, absorbed light heats and thermally tensions a suspended graphene resonator, thereby shifting its resonant frequency. Using the resonant frequency as a readout for photodetection, we achieve a room-temperature noise-equivalent power (2 pW Hz−1/2) and bandwidth (from 10 kHz up to 1.3 MHz), challenging the state-of-the-art.

15 February 2019 in Nano Letters
Verified
Journal Article
Closed access
JZJoshua Ziegler
Joshua Ziegler
RKRachael Klaiss
Rachael Klaiss
ABAndrew Blaikie
Andrew Blaikie
DMDavid Joseph Miller
David Joseph Miller
VHViva Rose Horowitz
Viva Rose Horowitz
BABenjamín J. Alemán
Benjamín J. Alemán

27 November 2018 in Nano Letters
Verified
Journal Article
Closed access
ELErik James Leonhardt
Erik James Leonhardt
JRJeff M. Van Raden
Jeff M. Van Raden
DMDavid Joseph Miller
David Joseph Miller
LZLev N. Zakharov
Lev N. Zakharov
BABenjamin J Aleman
Benjamin J Aleman
RJRamesh Jasti
Ramesh Jasti

27 March 2018 in Nano Letters
Verified
Journal Article
Closed access
JZJoshua Ziegler
Joshua Ziegler
ABAndrew Blaikie
Andrew Blaikie
AFAidin Fathalizadeh
Aidin Fathalizadeh
DMDavid Miller
David Miller
FYFehmi S. Yasin
Fehmi S. Yasin
BABenjamin Jose Aleman
Benjamin Jose Aleman

16 August 2022 in The Journal of Chemical Physics
Verified
Journal Article
Closed access
PDF file
RKRachael Klaiss
Rachael Klaiss
JZJoshua Ziegler
Joshua Ziegler
DMDavid Miller
David Miller
KZKara Zappitelli
Kara Zappitelli
KWKenji Watanabe
Kenji Watanabe
BABenjamin Jose Aleman
Benjamin Jose Aleman
Many techniques to fabricate complex nanostructures and quantum emitting defects in low dimensional materials for quantum information technologies rely on the patterning capabilities of focused ion beam (FIB) systems. In particular, the ability to pattern arrays of bright and stable room temperature single-photon emitters (SPEs) in 2D wide-bandgap insulator hexagonal boron nitride (hBN) via high-energy heavy-ion FIB allows for direct placement of SPEs without structured substrates or polymer-reliant lithography steps. However, the process parameters needed to create hBN SPEs with this technique are dependent on the growth method of the material chosen. Moreover, morphological damage induced by high-energy heavy-ion exposure may further influence the successful creation of SPEs. In this work, we perform atomic force microscopy to characterize the surface morphology of hBN regions patterned by Ga+ FIB to create SPEs at a range of ion doses and find that material swelling, and not milling as expected, is most strongly and positively correlated with the onset of non-zero SPE yields. Furthermore, we simulate vacancy concentration profiles at each of the tested doses and propose a qualitative model to elucidate how Ga+ FIB patterning creates isolated SPEs that is consistent with observed optical and morphological characteristics and is dependent on the consideration of void nucleation and growth from vacancy clusters. Our results provide novel insight into the formation of hBN SPEs created by high-energy heavy-ion milling that can be leveraged for monolithic hBN photonic devices and could be applied to a wide range of low-dimensional solid-state SPE hosts.

4 November 2019 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
DMDavid Miller
David Miller
BABenjamin Jose Aleman
Benjamin Jose Aleman
Emerging applications in nanoelectromechanical systems (NEMS) made from two-dimensional (2D) materials demand simultaneous imaging and selective actuation of the mechanical modes. Focused optical probes to measure and actuate motion offer a possible solution, but their lateral spatial resolution must be better than the size of the resonator. While optical interferometry is known to have excellent spatial resolution, the spatial resolution of the focused, laser-based optical driving is not currently known. Here, we combine separately scanned interferometry and optical drive probes to map the motion and forces on a suspended graphene nanomechanical resonator. By analyzing these maps with a force density model, we determine that the optical drive force has a spatial resolution on the order of the size of the focused laser spot. Using the optical force probe, we demonstrate the selective actuation and suppression of a pair of orthogonal antisymmetric mechanical modes of the graphene resonator. Our results offer a powerful approach to image and actuate any arbitrary high-order mode of a 2D NEMS.