Multifunctional thin films which can display both photocatalytic and antibacterial activity are of great interest industrially. Here, for the first time, we have used aerosol assisted chemical vapour deposition (AACVD) to deposit highly photoactive thin films of Cu-doped anatase TiO2 on glass substrates. The films displayed much enhanced photocatalytic activity relative to pure anatase, and showed excellent antibacterial (vs S.Aureus and E.Coli) ability. Using a combination of transient absorption spectroscopy (TAS), photoluminescence (PL) measurements and hybrid density functional theory calculations, we have gained nanoscopic insights into the improved properties of the Cu-doped TiO2 films. Our analysis has highlighted that the interactions between substitutional and interstitial Cu in the anatase lattice can explain the extended exciton lifetimes observed in the doped samples, and the enhanced UV/visible light photoactivities observed.
Gallium Phosphide (GaP) has a band gap of 2.26 eV and a valance band edge that is more negative than the water oxidation level. Hence, it may be a promising material for photoelectrochemical water splitting. However, one thing GaP has in common with other III-V semiconductors is that it corrodes in photoelectrochemical reactions. Cobalt oxide (CoOx) is a chemically stable and highly active oxygen evolution reaction co-catalyst. In this study, we protected a GaP photoanode by using a 20 nm TiO2 as a protection layer and a 2 nm cobalt oxide co-catalyst layer, which were both deposited atomic layer deposition (ALD). A GaP photoanode that was modified by CoOx exhibited much higher photocurrent, potential, and photon-to-current efficiency than a bare GaP photoanode under AM1.5G illumination. A photoanode that was coated with both TiO2 and CoOx layers was stable for over 24 h during constant reaction in 1 M NaOH (pH 13.7) solution under one sun illumination.
Photoelectrochemical production of hydrogen by using sunlight to split water offers a sustainable approach for clean energy generation. III–V semiconductors have shown the highest efficiencies for photoelectrochemical water splitting but the prohibitive cost of commercial single-crystalline GaP wafers limit practical use and large-scale application. Here, we report a high-quality GaP photocathode directly grown on a silicon substrate by solid-source molecular beam epitaxy. The photocathode can be stabilized under acidic electrolyte 1 M HClO4 (pH 0) by combining an amorphous TiO2 layer coated with a molybdenum sulphide MoS2 hydrogen evolution catalyst by atomic layer deposition (ALD). Under simulated AM 1.5G solar illumination, the Si/GaP photocathode yielded a maximum photocurrent density of 0.95 (mA cm−2) with a proton reduction onset potential of 467 mV versus the reversible hydrogen electrode. The average faradaic efficiency of the Si/GaP photocathode was measured to be over 73.4 ± 20.2% for over 100 minutes. The photoelectrochemical studies for the Si/GaP photocathode show the potential for widespread deployment of cost-effective photoelectrodes for hydrogen generation.
Hydrogen produced using artificial photosynthesis, i.e. solar splitting of water, is a promising energy alternative to fossil fuels. Efficient solar water splitting demands a suitable band gap to absorb near full spectrum solar energy and a photoelectrode that is stable in strongly alkaline or acidic electrolytes. In this work, we demonstrate for the first time, a perfectly relaxed GaP0.67Sb0.33 monocrystalline alloy grown on a silicon substrate with a direct band gap of 1.65 eV by molecular beam epitaxy (MBE) without any evidence of chemical disorder. Under one Sun illumination, the GaP0.67Sb0.33 photoanode with a 20 nm TiO2 protective layer and 8 nm Ni co-catalyst layer shows a photocurrent density of 4.82 mA cm−2 at 1.23 V and an onset potential of 0.35 V versus the reversible hydrogen electrode (RHE) in 1.0 M KOH (pH = 14) aqueous solution. The photoanode yields an incident-photon-to-current efficiency (IPCE) of 67.1% over the visible range between wavelengths 400 nm to 650 nm. Moreover, the GaP0.67Sb0.33 photoanode was stable over 5 h without degradation of the photocurrent under strong alkaline conditions under continuous illumination at 1 V versus RHE. Importantly, the direct integration of the 1.65 eV GaP0.67 Sb0.33 on 1.1 eV silicon may pave the way for an ideal tandem photoelectrochemical system with a theoretical solar to hydrogen efficiency of 27%.