This article presents a fully integrated stand-alone narrowband Internet-of-Things (NB-IoT) and global navigation satellite system (GNSS) system-on-chip (SoC). It aims for an all-in-one system to integrate all necessary blocks such as an RF transceiver, a power management system (PMIP), and a clock management system and to save a bills-of-material (BOM) cost. An RF transceiver is integrated to support multi-band cellular IoT and GNSS with a CMOS RF power amplifier transmitting 23-dBm output power. A PMIP, including bucks, a boost, and low-dropout regulators (LDOs), is integrated to support coin cell or AAA battery and to support a wide input supply voltage range from 2.5 to 5 V. In addition, clock management system is embedded with a digitally controlled crystal oscillator (DCXO), a relaxation oscillator (RCO), and temperature sensor units (TSUs). It is fabricated in a standard 28-nm CMOS process and its size is 24.6 mm². The power consumption of always-on-block is 15 μW, and the sleep current consumption is less than 10 μA at 3.8 V.
22 August 2024 in IEEE Journal of Solid-State Circuits
A high-linearity, wideband transceiver for Wi-Fi 7 to support 4 K-QAM 320 MHz bandwidth (BW) is presented and fabricated using a 14 nm Fin-FET CMOS process. To provide a high-performance local oscillator (LO) signal, a fractional-N sampling phase-locked loop with a high gain sampling phase detector (SPD) is implemented with digital-to-time converter (DTC) non-linearity calibration (NLC) based on a least mean square (LMS) algorithm. The transceiver exhibits excellent integrated phase noise (IPN) performances with a single-core voltage-controlled oscillator (VCO) achieving $-$ 54.3 dBc at 7115 MHz frequency channel. IPN performance can be further improved to $-$ 55.2 dBc with a dual-core VCO. A wideband frequency operation transmitter (TX) architecture for a 5–7 GHz frequency range is introduced. It utilizes a high $Q$ tunable switched inductor for a wideband matching network and flexible frequency adjustment. A coupling-minimized switched inductor (CMSI) is implemented to cancel out magnetic flux when two inductors are enabled simultaneously. This improves mutual inductance and the $Q$ factor while extending the frequency tuning range. The TX error vector magnitude (TX EVM) floor is achieved up to $-$ 46.1 dB at 7.1 GHz, marking the best-reported value to date. A 5/6G receiver (RX) is designed to improve noise performance while maintaining linearity. To achieve this, a resistor attenuator block is introduced between a voltage-to-current (V2I) and a mixer, while a high signal-to-noise-and-distortion ratio (SNDR) performance is maintained in a wider input power range. The RX error vector magnitude (RX EVM) floor is measured as $-$ 46 dB at 7.1 GHz. These results demonstrate the transceiver’s excellent performance, making it a promising solution for Wi-Fi 7 applications.