4 July 2018 in Green Chemistry
Nanomaterials (NMs) are gaining increasing commercial importance due to a variety of properties that cannot be achieved with bulk materials. Yet the assessment of their environmental impacts lags behind the technological development. First attempts towards designing inherently safer NMs have been made, yet we are still unable to formulate rules of green nano-design, especially in terms of mitigating (long-term) toxicity and bioaccumulation. Importantly, NMs released to the environment acquire a so called ‘environmental corona’ – a complex layer of spontaneously adsorbed biomolecules – that significantly impacts their behaviour and fate. This review integrates the current literature on the impact of environmental conditions on NMs fate and behaviour, including corona formation, colloidal stability, reactivity, and toxicty, using a broad range of environmentally relevant NMs. Collectively, components of natural waters (such as salts and/or natural organic matter) often mitigate negative impacts of NMs via different mechanisms including surface passivation and stabilisation against dissolution. The review concludes by discussing some initial strategies on how to rationally design more environmentally acceptable NMs.
1 June 2014 in Science of The Total Environment
20 June 2017 in Environmental Science: Nano
The use of silver nanoparticles (AgNPs) as an antimicrobial agent has increased significantly over the past decade which potentiates their release to the environment. The antimicrobial effect of AgNPs is generally considered to be due to the release of silver ions (Ag+). Here we describe their bioavailability under environmental conditions and demonstrate its influence on (eco-)toxicity for the AgNP NM-300K and a wide variety of aquatic organisms (green algae, plants and crustaceans), terrestrial organisms (soil bacteria) and mammalian cells. Since the bioavailability of AgNPs is largely determined by Ag speciation, this paper focuses on the Ag speciation in the test media for these organisms. We predicted the Ag speciation in aqueous test media by equilibrium speciation calculation and validated the results by comparison with experimental speciation using ultracentrifugation and membrane filtration. Silver amounts were quantified using GF-AAS, ICP-OES/MS and UV-vis. The dissolved Ag concentrations were controlled by the fast initial release of a limited amount of Ag+. After this initial release, the media components, chloride and proteins, controlled the available dissolved Ag by precipitation and complexation. Further release of Ag+ due to oxidation was not observed in the time frame of our experiments, except for media with very high chloride content. Apparently, the stabilisers of these AgNPs prevented any further release accounting for an enhanced redox stability. These findings facilitated the prediction of the bioavailability of Ag in the test media and, based on literature toxicity data, also of its toxic effects (EC50) on the respective organisms. The toxic effects of the AgNP NM-300K depended solely on the amount of Ag+ that was already present in the stock dispersion and not from further release due to later oxidation processes.
13 July 2023 in Microplastics and Nanoplastics
Since 2015, the determination of microplastics (MPs; < 5 mm) in soil has gained increasing attention. However, usual analytical protocols still render a comparison of results challenging. This structured review integrates an in-depth screening of scientific articles (n = 106; from 1980 to 2022) that focused on determining MPs in soils. The different studies were divided into groups regarding (i) MPs input pathways, (ii) study site information, (iii) sampling design, (iv) sample preparation, and (v) analytical methods for MPs detection. Most of the studies (63%) focused on a defined study site influenced by a known point source, whereas 37% measured MPs background contents related to delocalized MPs emission sources. Even though soil was the target compartment, only 26% classified the soil type, mostly using the World Reference Base (WRB) as a classification system. Additional information on soil properties was supplied within only 20% of the studies. However, this information is mandatory for evaluation of MPs recovery tests and analytical results. In nearly all studies, the mass of the single samples equaled the final mass of the composite sample, with a mean of 1.32 kg ± 1.07 kg. However, other procedures that involve a larger sample mass seem promising but are still seldom applied. Our structured review revealed that a standard operation procedure with harmonized methods is urgently needed with a coherent and comprehensive workflow, including field sampling and sample preparation. Such a procedure would ensure the reproducibility and representativeness of analytical results, which are mandatory for evaluating and restricting MPs pollution in soils in the future. Graphical Abstract
10 August 2023 in Environmental Science & Technology