The development of a high-performance sensing material for the detection of ammonia gas is of significant importance due to its wide industrial presence and potential hazard risks. In this article, we report the synthesis of porous and hollow MoO 3 (p-h-MoO 3 ) microspheres via the oxidation of MoS 2 microsphere templates, which are obtained via self-assembly of MoS 2 nanosheets under hydrothermal conditions. The composition and morphology of the p-h-MoO 3 microspheres are systematically characterized via microscopic and spectroscopic techniques, and our sensing tests reveals that p-h-MoO 3 possesses ultrahigh responsiveness to ammonia gas, which can be further optimized via the selection of a suitable oxidation temperature and time. Additionally, the p-h-MoO 3 shows minimal responses to other gaseous molecules, thereby demonstrating significant selectivity toward ammonia. The sensing mechanism of p-h-MoO 3 toward ammonia is further investigated to identify the origin of its ultrahigh sensitivity and selectivity via X-ray photoelectron spectroscopy and diffuse reflectance Fourier transform infrared spectroscopy.
16 July 2021 in IEEE Transactions on Instrumentation and Measurement
Xylene is a toxic carcinogen, which may irritate eyes and respiratory tract, or damage the central nervous system. However, the traditional semiconductor gas sensor can only detect the ppm level of xylene gas, which cannot meet the building air quality monitoring requirements. Therefore, the development of low concentration gas detection of xylene gas sensor is necessary. In this article, a one-step hydrothermal method for the preparation of reduced graphene oxide (rGO)/Co 3 O 4 nanocomposite was reported. Then, rGO/Co 3 O 4 nanocomposites were characterized by various characterization methods. It was found that the structure of cobalt tetroxide (Co 3 O 4 ) nanoparticle-coated rGO nanosheets was successfully synthesized. Specific internal morphology could be seen by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Then the gas sensor made of rGO/Co 3 O 4 nanocomposite material was tested for its gas sensitivity performance. A series of properties such as repeatability and stability of the material were tested. According to the test results, the sensitivity of 1rGO/Co 3 O 4 (3.35 wt%) to xylene gas was better than that of 2rGO/Co 3 O 4 (5.54 wt%) and pure Co 3 O 4 , and the optimal working temperature of rGO/Co 3 O 4 to 50 ppm xylene was 175 °C, which was 50 °C lower than that of pure Co 3 O 4 . In addition, the rGO/Co 3 O 4 gas sensor could also detect xylene gas with a minimum concentration of 1 ppb. Finally, the gas sensing mechanism of the gas sensor for xylene gas was analyzed.
14 September 2021 in IEEE Transactions on Nanotechnology
In this paper, gas sensing characteristics of Boron-doped graphene oxide(B-GO) are presented firstly. In order to detect the optimal value of boron doping, different amounts of boron (5-30 wt%) are adopt in the doping process. The results of sensing test revealed that at room temperature (20 °C) and humidity (30%), 15 wt% B-GO has the optimal sensitivity to NH 3 . Meanwhile, the detection response and recovery time of B-GO gas sensor to NH 3 are relatively short. Theoretical models of graphene and B-doped graphene are established, and energy change in the gas-adsorption of NH 3 on the graphene oxide or B-doped graphene oxide is calculated. The enhanced sensing performance was ascribed to the B-doping and the formation of chemical bonds between boron and NH 3 .
18 November 2021 in Journal of Physics and Chemistry of Solids