In this letter, we mathematically analyze the bit-error-rate (BER) and frame-error-rate (FER) performance of the resource hopping-based grant-free multiple access (RH-GFMA) systems that were recently proposed for 6G massive Internet-of-Things (mIoT) networks. In the RH-GFMA systems, each IoT device intermittently sends a short-packet to the access point (AP) based on a predetermined resource hopping pattern (HP). Each IoT device may experience HP collisions within the packet, but the effect of HP collisions on error performance can be reduced to be collision-friendly by exploiting multi-antenna-based signal detection and error-correction capability of channel codes. In this letter, hence, we rigorously analyze the effect of HP collisions on the error performance in the RH-GFMA system where repetition codes (RC) and tail-biting convolutional codes (TB-CC) are considered channel coding schemes for satisfying low-complexity and low-latency requirements of mIoT networks. Through computer simulations, we validate that our mathematical analysis is well-matched with the simulation results.
This paper outlines the time jitter effect of a sampling clock on a Software Defined Radio (SDR) technology- based-Digital Intermediate Frequency (IF) transceiver for a mobile communication base station. The implemented Digital IF transceiver is reconfigurable to three bandwidth profiles : 1.75 MHz, 3.5 MHz, and 7 MHz each incorporating the IEEE 802.16d Worldwide Interoperability for Microwave Access (WiMAX) standard and High-Speed Downlink Packet Access (HSDPA) standard. This transceiver can be reconfigured to other standard profiles through software downloaded onto identical hardware platforms, without changing any components or parts on board. This paper examines the relationship between the Signal-to- Noise Ratio (SNR) characteristics of a Digital IF transceiver with an under-sampling scheme and the sampling jitter effect on a multi-channel OFDM signal and a multi-code CDMA signal. The experimental results show that the SNR of the multi-channel OFDM system is more susceptible to sampling clock jitter compared to a multi-code HSDPA system.
The data rate between remote radio head (RRH) and baseband unit (BBU) in the distributed base station architecture is steeply increasing due to the new technologies such as multiple input multiple output (MIMO), coordinated multi-point (CoMP), carrier aggregation (CA) and multiband support. Compression of baseband signal is an efficient way to reduce the data rates on the optical fiber link. Compression can be achieved by eliminating redundancy resides in typical base band I/Q signals. This paper proposes two block scaling schemes for I/Q baseband signal compression, which enables low latency transport of the signal between BBU and RRH. Low latency is mainly achieved by reduced header information, which enables the block to diminish. The evaluation results suggest that the proposed schemes are promising in that they minimize the error vector magnitude (EVM) degradation in the reduced size of blocks and guarantee low latency. Proposed schemes can be applied efficiently to noisy uplink as well as downlink due to the scaling in accordance with the effective bit width of the signal.