1 October 2020 in AIP Advances
We investigate analytically the anisotropic dielectric properties of single-crystal α-SnS near the fundamental absorption edge by considering atomic orbitals. Most striking is the excitonic feature in the armchair- (b-) axis direction, which is particularly prominent at low temperatures. To determine the origin of this anisotropy, we perform first-principles calculations using the GW0 Bethe–Salpeter equation including the electron–hole interaction. The results show that the anisotropic dielectric characteristics are a direct result of the natural anisotropy of p orbitals. In particular, this dominant excitonic feature originates from the py orbital at the saddle point in the Γ–Y region.
18 August 2016 in Journal of the Korean Physical Society
The strain effect on electronic structure and thermoelectric properties of Higher Manganese Silicides (HMSs) Mn4Si7 was studied using Density Functional Theory (DFT) and through solving Boltzman Transport Equation (BTE). We found that the tensile strain attempts to reduce the band gap while the compressive strain not much affect to band gap. The Seebeck coeficient was found to be increased with increasing temperature, which is very consistent to experiments. The electrical conductivity and power factor show highly degree of anisotropy, where in-plane direction is more dominant. The different behavior of electrical conductivity along in-plane and outof plane direction was explained due to the change of band dispersion in the valence band maximum (VBM)
1 October 2025 in Physical Review B
10 July 2026 in Journal of Vacuum Science & Technology A
In this study, we investigated the effect of the Se/In flux ratio on the structural and optical properties of In2Se3 thin films grown on a Si(111) substrate via molecular beam epitaxy. All films were epitaxially grown at 300 °C with Se/In flux ratios of 3.6, 5, and 7. X-ray diffraction and Raman spectroscopy revealed that films grown at flux ratios of 3.6 and 7 contained a mixture of hexagonal γ- and β-In2Se3 phases, whereas the film grown at a ratio of 5 was single-phase γ-In2Se3 with improved structural uniformity and ordering. Photoluminescence measurements revealed a dominant emission peak at 1.95 eV, attributed to γ-In2Se3, with the high intensity observed for the 5-ratio sample. A secondary lower-energy peak at 1.44 eV, associated with β-In2Se3, was detected in the 3.6 and 7 ratio samples. These results demonstrate that the combined influence of the nominal Se/In supply ratio and growth kinetics plays an important role in determining phase composition, structural uniformity, and optical emission in In2Se3 thin films, providing valuable insights for phase-engineered epitaxial growth in optoelectronic applications.