23 December 2021 in Journal of Advances in Modeling Earth Systems
Wide‐swath altimetry, for example, the Surface Water and Ocean Topography mission is expected to provide Sea Surface Height (SSH) measurements resolving scales of a few tens of kilometers. Over a large fraction of the globe, the SSH signal at these scales is essentially a superposition of a component due to balanced motions (BMs) and another component due to internal tides (ITs). Several oceanographic applications require the separation of these components and their mapping on regular grids. For that purpose, the paper introduces an alternating minimization algorithm that iteratively implements two data assimilation techniques, each specific to the mapping of one component: a quasi‐geostrophic model with Back‐and‐Forth Nudging for BMs, and a linear shallow‐water model with 4‐Dimensional Variational assimilation for ITs. The algorithm is tested with Observation System Simulation Experiments where the truth is provided by a primitive‐equation ocean model in an idealized configuration simulating a turbulent jet and mode‐one ITs. The algorithm reconstructs almost 80% of the variance of BMs and ITs, the remaining 20% being mostly due to dynamics that cannot be described by the simple models used. Importantly, in addition to the reconstruction of stationary ITs, the amplitude and phase of nonstationary ITs are reconstructed. Sensitivity experiments show that the quality of reconstruction significantly depends upon the timing of observations. Although idealized, this study represents a step forward towards the disentanglement of BMs and ITs signals from real wide‐swath altimetry data.
15 January 2025 in Ocean Science
VBValentin Bellemin-Laponnaz
Valentin Bellemin-Laponnaz
+6
Real-time observation of ocean surface topography is essential for various oceanographic applications. Historically, these observations have mainly relied on satellite nadir altimetry data, which were limited to observation scales greater than approximately 60 km. However, the recent launch of the wide-swath Surface Water Ocean Topography (SWOT) mission in December 2022 marks a significant advancement, enabling the two-dimensional global observation of finer-scale oceanic scales (∼ 15 km). While the direct analysis of the two-dimensional content of these swaths can provide valuable insights into ocean surface dynamics, integrating such data into mapping systems presents several challenges. This study focuses on integrating the SWOT mission into multi-mission mapping systems. Specifically, it examines the contribution of the SWOT mission to both the current nadir altimetry constellation (six/seven nadirs) and a reduced nadir altimetry constellation (three nadirs). Our study indicates that within the current nadir altimetry constellation, SWOT's impact is moderate, as existing nadir altimeters effectively constrain surface dynamics. However, in a hypothetical scenario where a reduced nadir altimetry constellation is envisioned to be operational by 2030, the significance of wide-swath data in mapping becomes more pronounced. Alternatively, we found that data-driven and dynamical mapping systems can significantly participate in refining the resolution of the multi-mission gridded products. Consequently, integrating high-resolution ocean surface topography observations with advanced mapping techniques can enhance the resolution of satellite-derived products, providing promising solutions for studying and monitoring sea-level variability at finer scales. However, to fully exploit SWOT's capabilities, future research will need to focus on innovations in data gridding and assimilation to extend mapping beyond geostrophically balanced flows.
28 August 2025 in Journal of Geophysical Research: Oceans
Observations of sea surface height (SSH) from the Surface Water and Ocean Topography (SWOT) satellite have demonstrated remarkable potential for resolving mesoscale and submesoscale ocean features, which are crucial for deriving vertical velocities, a key variable for understanding the transport of heat, carbon, and nutrients between the ocean surface and interior. In the mesoscale energetic region south of Tasmania, we evaluate the accuracy of SWOT small‐scale observations using high‐resolution (8 km) in situ observations of surface tracer fields and vertical temperature. Surface features derived from SWOT align with subsurface horizontal temperature gradients derived from the in situ measurements. These fine scales (100 km) reveal dynamic phenomena, such as a sudden front deflection near the Macquarie Ridge, obscured in conventional low‐resolution products. We then quantify the contributions of these small scales to the currents' energy and shape, compared to the larger mesoscales (100 km) observable with traditional nadir‐looking altimetry. Although larger scales predominantly influence the geostrophic velocity, smaller scales contribute significantly to current stretching and straining, showing up to threefold stronger strain and tenfold stronger vorticity than larger scales in a few hotspots. Finally, we investigate the contribution of these small scales to the vertical velocities down to 1,000 m that are reconstructed using effective surface Quasi‐Geostrophic theory. SWOT‐derived exhibit twice the amplitude compared to nadir altimetry, underscoring SWOT's capacity to resolve energetic meso‐ and submesoscale ocean dynamics. These results highlight the need to fully harness SWOT's high‐resolution data in gridded products, as current smoothing limits the retention of valuable small‐scale information.
21 April 2025 in Journal of Advances in Modeling Earth Systems
The VarDyn hybrid methodology, which combines minimal physically based constraints with a variational scheme, is demonstrated to enhance the mapping of sea surface height (SSH) and sea surface temperature (SST). By synthesizing multi‐modal satellite observations, VarDyn produces SSH and SST maps with improved accuracy compared to operational products, achieving reductions in Root Mean Square Error and enhancements in effective spatial resolution. While most improvements are observed in highly energetic ocean regions, SSH map accuracy also improves slightly in low‐energy regions—a significant advancement over other methods. VarDyn SSH fields and the associated geostrophic velocities show strong agreement with newly available high‐resolution instantaneous SWOT estimates. Notably, the assimilation of SST proves particularly beneficial for SSH reconstruction when only two altimeters are available. The VarDyn methodology potentially offers a robust framework for refining climate SSH records by jointly assimilating SSH data from two altimeters and SST data from microwave sensors.
26 October 2023 in Ocean Science
For over 25 years, satellite altimetry has provided invaluable information about the ocean dynamics at many scales. In particular, gridded sea surface height (SSH) maps allow us to estimate the mesoscale geostrophic circulation in the ocean. However, conventional interpolation techniques rely on static optimal interpolation schemes, hence limiting the estimation of non-linear dynamics at scales not well sampled by altimetry (i.e., below 150–200 km at mid-latitudes). To overcome this limitation in the resolution of small-scale SSH structures (and thus small-scale geostrophic currents), a back-and-forth nudging algorithm combined with a quasi-geostrophic model, a technique called BFN-QG, has been successfully applied on simulated SSH data in observing system simulation experiments (OSSEs). The result is a significant reduction in interpolation error and an improvement in the space–time resolutions of the experimental gridded product compared to those of operational products. In this study, we propose that the BFN-QG be applied to real altimetric SSH data in a highly turbulent region spanning a part of the Agulhas Current. The performances are evaluated within observing system experiments (OSEs) that use independent data (such as independent SSH, sea surface temperature and drifter data) as ground truth. By comparing the mapping performances to the ones obtained with operational products, we show that the BFN-QG improves the mapping of short, energetic mesoscale structures and associated geostrophic currents both in space and time. In particular, the BFN-QG improves (i) the spatial effective resolution of the SSH maps by a factor of 20 %, (ii) the zonal and (especially) the meridional geostrophic currents, and (iii) the prediction of Lagrangian transport for lead times up to 10 d. Unlike the results obtained in the OSSEs, the OSEs reveal more contrasting performances in low-variability regions, which are discussed in the paper.