Wireless power transfer (WPT) using far-field microwave radiation beam can be used to power unmanned aerial vehicles (UAVs) thus eliminating the need to land on the ground to charge. In a distributed WPT system, impulse radio ultrawideband (IR-UWB) signals can provide continuous power at the receiver end with a high rectification efficiency. Such far-field based distributed WPT systems require high gain ultrawideband (UWB) antenna arrays with a unidirectional radiation patterns and beam steering capability. This paper proposes a $4\times 4$ phased array antenna with an ultrawideband (UWB) operating frequency range of $7.5-8.5 GHz$ and $20.9 dBi$ gain. The novelty of this work lies in the design of a single unit antenna to achieve UWB operation while maintaining high gain and unidirectional radiation pattern. Another contribution of this work is the determination of the array element spacing based on the theoretical modeling and simulation and measurement based validation to achieve the highest gain, minimum coupling coefficient, and lower side lobe level (SLL). In order to achieve beam steering, each $2\times 2$ subarray is considered as a single quadrant thus dividing the $4\times 4$ phased array antenna into four quadrants where all 16 single elements are individually fed. The far-field radiation beam is steered by controlling the phase difference between each quadrant. The proposed phased array antenna achieves a scanning range $ > 51^{\circ }$ with 28° half power beam width (HPBW), gain ranging from $15.4 dBi$ to $20.9 dBi$ , and a maximum scanning loss of $2.8 dB$ over the UWB operating frequency range.
Over the last few decades, far-field RF-based wireless power beaming (WPB) has been a topic of interest for the microwave and the antenna engineering communities alike, and there have been quite a few articles published in the IEEE Microwave Magazine related to this topic in the last 20 years, which is evidence of the high interest of the community. This interest is likely due to the dire need for such a system for applications, ranging from biomedicine to drone charging [1] , [2] , [3] , [4] , [5] . While these prior published articles have been a great resource for new researchers in this area, who can gather tons of resources and information by reading these articles, we (the authors of this article) realized a comprehensive review is still lacking, where the challenges and opportunities regarding WPB to dynamically and rapidly moving targets [e.g., unmanned aerial vehicles (UAVs)] using multiple, distributed transmitters (TXs) are summarized and discussed in detail. We envision that the next generation of wireless power transfer (WPT) networks will be scalable, safe, and efficient, enabling a robust RF energy web that can be deployed using mobile autonomous platforms, such as unmanned aerial systems, as depicted in Figure 1 .
16 November 2023 in IEEE Open Journal of Antennas and Propagation
Diagnosis of neural diseases can be performed using microsystems that record neural signals collected simultaneously after neural simulations. Headstage and homecage-based recording systems can be implanted on small freely-moving animals to test such system which requires miniaturized, lightweight, and high gain antennas in order for the small animals to carry them easily while also decreasing loss during data transmission. This paper proposes a 15×15 mm slot antenna with a 50 Ω microstrip excitation line. The slot antenna is created by the addition of slots in the ground plane which is a common miniaturization method as it results in ultrawideband operating frequency. A lumped component-based model along with a 3D EM model of the modified SMA connector used for the measurement and headstage model is also developed to observe the effect on the antenna performance. The antenna achieved an operating frequency of 4.25 -9.4 GHz and a bidirectional radiation pattern with gain ranging from 2.24 to 4.35 dBi. The proposed antenna is also circularly polarized and achieves 80.6% -90.8% radiation efficiency over the operating BW. It can transmit a maximum of 20 dBm of power over the operating frequency without exceeding the FCC-imposed SAR limit. Based on the performance, the antenna is suitable for headstage and homecage-based neural signal recording systems with IR-UWB transmitter for high data rate transmission.
11 May 2026 in IEEE Journal on Wireless Power Technologies
This work presents an experimental radiative wireless power transfer (WPT) system that utilizes array antennas excited by an Impulse Radio Ultrawideband (IR-UWB) waveform and achieves a high RF-RF efficiency. The proposed system features a 16×32 tapered slot Vivaldi antenna array as the transmitter (TX) and a 10×12 metasurface-based multilayer antenna array as the receiver (RX), both optimized for ultrawideband operation from 3.5 - 4.5 GHz with high gains (>28.7 dBi) and narrow beamwidths (2x the RF-RF efficiency improvement compared to the conventional continious wave (CW) signal-based WPT under identical setup. The results demonstrate that combining IR-UWB waveform with high-gain array antennas enables efficient, compact, and scalable WPT systems for next-generation of microwave-based power beaming applications.
1 October 2026 in IEEE Open Journal of Antennas and Propagation