Optimum conditions for the direct reversed-phase LC determination of fluoride based on the ternary M–F––(5-Br-PADAP) complexes [M = ZrIV or HfIV and 5-Br-PADAP = 2-(5-bromo-2-pyridylazo)- 5-diethylaminophenol] were evaluated. Chromatographic separation was performed with C18 end-capped column with an eluent consisting of acetonitrile–water (85 +15 v/v) mixture of pH 4.0 ± 0.3 (flow rate 1 ml min–1), and the eluate was monitored spectrophotometrically at λmax = 585 nm. The calibration curves were linear over a wide range of fluoride concentrations: from 1 to 110 and 150 ng ml–1 for the ZrIV–F––(5-Br-PADAP) and HfIV–F––(5-Br-PADAP) systems, respectively (using a 20 µl loop). Under such conditions the detection limits were 0.8 and 0.7 ng ml–1, respectively, and the quantification limit is 1.0 ng ml–1 for both methods. When a 100 µl loop was used, the limits of both detection and quantification in the method based on the zirconium system were 0.2 ng ml–1. Using the proposed method, fluoride was determined directly in tap water, saliva and an anti-cancer agent for prostatic cancer (Leuprolid).
1 April 1997 in Berichte der Bunsengesellschaft für physikalische Chemie
A selective, sensitive and low sample consumption GC method for determination of residual solvents in PSMA samples was developed. Selectivity with respect to solvents such as ethanol, diethyl ether, 2-propanole, acetonitrile, dichloromethane, used in manufacturing of PSMA-11, was obtained on two different GC systems and columns. In all these cases, good separation and other system suitability parameters were obtained. The values of detection limit (LOD) and limit of quantitation (LOQ) were estimated and verified experimentally for ethanol, diethyl ether, 2-propanol (IPA), acetonitrile (ACN) and dichloromethane. Full validation parameters i.e.: selectivity, limit of detection (LOD), limit of quantitation (LOQ), linearity, precision, accuracy, robustness and system suitability parameters are presented with respect to ACN and IPA. Accuracy and precision were measured on two GC systems. Statistical tests exhibit, that there are no significant differences in accuracy and precision between two GC systems