2 February 2018 in Science Advances
Fault slip during plate boundary earthquakes releases a portion of the shear stress accumulated due to frictional resistance to relative plate motions. Investigation of 101 large [moment magnitude (Mw) ≥ 7] subduction zone plate boundary mainshocks with consistently determined coseismic slip distributions establishes that 15 to 55% of all master event–relocated aftershocks with Mw ≥ 5.2 are located within the slip regions of the mainshock ruptures and few are located in peak slip regions, allowing for uncertainty in the slip models. For the preferred models, cumulative deficiency of aftershocks within the central three-quarters of the scaled slip regions ranges from 15 to 45%, increasing with the total number of observed aftershocks. The spatial gradients of the mainshock coseismic slip concentrate residual shear stress near the slip zone margins and increase stress outside the slip zone, driving both interplate and intraplate aftershock occurrence near the periphery of the mainshock slip. The shear stress reduction in large-slip regions during the mainshock is generally sufficient to preclude further significant rupture during the aftershock sequence, consistent with large-slip areas relocking and not rupturing again for a substantial time.
27 November 2020 in Science Advances
A 220-ka-long M w ≥ 7.0 earthquake record reveals an unexpectedly high seismicity rate on a slow-slipping plate boundary.
2 December 2016 in Geophysical Research Letters
The total number of aftershocks increases with main shock magnitude, resulting in an overall well‐defined relationship. Observed variations from this trend prompt questions regarding influences of regional environment and individual main shock rupture characteristics. We investigate how aftershock productivity varies regionally and with main shock source parameters for large (Mw ≥ 7.0) circum‐Pacific megathrust earthquakes within the past 25 years, drawing on extant finite‐fault rupture models. Aftershock productivity is found to be higher for subduction zones of the western circum‐Pacific than for subduction zones in the eastern circum‐Pacific. This appears to be a manifestation of differences in faulting susceptibility between island arcs and continental arcs. Surprisingly, events with relatively large static stress drop tend to produce fewer aftershocks than comparable magnitude events with lower stress drop; however, for events with similar coseismic rupture area, aftershock productivity increases with stress drop and radiated energy, indicating a significant impact of source rupture process on productivity.
28 July 2019 in Geophysical Research Letters
In 2013 and 2018, earthquake swarms with a maximum moment magnitude of 4.5 occurred ~5 km from the northern section of the Dead Sea Transform Fault. Here we show that aquifer pressure data, interferometric synthetic aperture radar surface deformation time series, and seismic monitoring suggest that groundwater withdrawal triggered these earthquakes. Continuous groundwater extraction from several wells located ~10 km west of the swarms has accelerated since 2010 and resulted in a total decrease of ~50 m of the groundwater level at the time of the 2018 earthquake swarm. The withdrawal also corresponds to surface subsidence of ~10 mm/year based on repeat interferometric synthetic aperture radar measurements. The temporal correlation, extensive subsidence, anomalous swarm characteristics, and normal faulting orientation suggest a connection between the groundwater withdrawal and recent earthquakes. Poroelastic modeling demonstrates that pumping‐induced pore pressure decrease west of the earthquake could have caused significant dilatational stresses that led to normal faulting events outside the aquifer.
6 January 2016 in Seismological Research Letters
More than 15,000 seismic events were recorded by the Israel Seismic Network (ISN) during the past 30 years, at the vicinity of the Dead Sea fault (DSF) zone. During those years, locations were obtained using several velocity models, which resulted in inconsistent locations. In addition, we found that seismicity is biased to very shallow depth estimations that do not match other estimations of more localized studies in the region. This study is focused on improving the regional earthquake catalog using robust single‐event location software (within the Antelope software), based on two seismic velocity models: (1) a local model (Gitterman et al., 2005) and (2) a global model (Kennett and Engdahl, 1991). The relocated events show more reasonable depth distributions, in accordance with the seismotectonic settings of the region, and the local velocity model shows smaller location errors than the global velocity model, suggesting better convergence of the location solutions. We also demonstrate and analyze the difference in the event‐station distribution, showing location effects of a sparse network, in which the main effect is seen for the focal depths: events located out of the network coverage tend to obtain a focal depth shallower than events located within the network coverage. The depth cross section along the DSF zone, within the boundaries of this study, presents a good correlation with previous estimation of the boundaries of the seismogenic zone, obtained by heat‐flow analysis. The relocated earthquake catalog is regarded as the new initial robust locations of the seismic bulletin of the ISN and considered as the basis for future studies and for more elaborated relocations; it is open to the public and can be downloaded from the Geological Survey of Israel website at https://www.gsi.gov.il (last accessed December 2015).