In the realm of advanced materials engineering, the development of hybrid nanocomposites has garnered significant attention due to their superior mechanical properties and potential applications. The primary aim of this research is to develop a surface hybrid nanocomposite using Al1050 aluminium alloy (5 mm thickness) as the base material through friction stir processing. B2O3 nano-powder, averaging 100 nm in size, and Cu micro-powder, averaging 5 μm in size, were incorporated into the aluminium surface in various volume ratios using the Friction Stir Processing (FSP). The processing parameters included a tool rotational speed of 1250 rpm, a feed rate of 50 mm min−1, and a tilt angle of 3°. The number of passes was set at two levels: 1 and 3 passes. The influence of the volume ratio of constituents and the number of passes on the microstructure and mechanical properties of the resulting composite was thoroughly explored. The samples underwent tensile tests, microhardness tests, and metallographic examinations using both Optical Microscopy (OM) and Field Emission Scanning Electron Microscopy (FE-SEM). The composite with 25%-B2O3-75%-Cu composition exhibited the highest stress and hardness values, measuring 139 MPa and 58.14 HV, respectively. The enhanced strength of this sample is attributed to the presence of additives and the resultant grain size.
This paper presents a novel TTR mechanism, also known as a 2T1R (2-Translation-1-Rotation) three-degree-of-freedom planar mechanism, achieved through the arrangement of three nested circular plates. With its ample workspace and high stiffness, this mechanism is well-suited for a variety of industrial applications. The study begins with an exploration of the mechanism’s degree of freedom using screw theory, followed by mathematical modelling of its direct and inverse kinematics for optimal movement between points. Employing an algorithm to eliminate redundant responses, programming and analysis are conducted in LabVIEW. To ensure precise motion of the end effector through designated points, cubic spline interpolation is utilized, with coding implemented in LabVIEW following mathematical analysis of spline equations. Additionally, two distinct motion paths are considered. This examination reveals the mechanism’s ability to traverse linear and circular paths with minimal error. The mechanism demonstrates acceptable accuracy in executing circular trajectories, as confirmed through experimental validation. Verification of the real path’s conformity to the simulated path involves detecting the end effector’s motion using linear and circular sensors, with results recorded and compared to the simulated trajectory. The findings demonstrate consistency between the experimental and simulated results.