3 August 2018 in BioMedical Engineering OnLine
The area of application of electronic stethoscopes in medical diagnostics covers the scope of usability of the acoustic stethoscopes, from which they have evolved and which they could potentially replace. However, the principle of operation of these two groups of diagnostic devices is substantially different. Thus, an important question arises, regarding the differences in parameters of the transmitted sound and their potential diagnostic consequences in clinical practice. In order to answer this question, heart auscultation signals are recorded using various stethoscopes and divided into short fragments based on the analysis of the synchronized recordings of electrocardiogram signals. Next, a dedicated algorithm is used to extract representative datasets for each case, which are then analyzed for their acoustic parameters. Four different electronic stethoscopes were investigated, together with an acoustic stethoscope as a reference point. The determined acoustic characteristics of the considered stethoscopes differ significantly between each other. The differences in sound transmitted by various stethoscope models may translate into significant differences in quality of the obtained diagnosis. It is also pointed out, that the terminology and application guidelines regarding the electronic stethoscopes are misleading and should be changed.
1 March 2017 in The Journal of the Acoustical Society of America
The present study introduces a detailed methodology which can be applied for objective evaluation and comparison of the acoustic parameters of medical stethoscopes using auscultation sounds as test signals. The described approach allows taking into account the acoustic coupling between the body of an auscultated patient and the chest piece of a stethoscope. Information obtained from additional, synchronized electrocardiography measurements is used to extract short, specific fragments of recordings, defined as acoustic events. Analysis of the spectral characteristics of many acoustic events allows us to compare the acoustic properties of various stethoscopes and to estimate the measurement uncertainty. The exemplary results of the comparative evaluation of acoustic properties of bell and diaphragm-type chest pieces of a single stethoscope are presented. The results show that the frequency characteristics of the signals obtained using both examined chest pieces under the conditions of the performed examinations are very similar.
26 September 2022 in IEEE Sensors Journal
Fish detection in shallow water conditions or close to the bottom poses specific challenges, which often can hardly be addressed using typical acoustical or optical means. This significantly limits the possibilities of fish population monitoring and the use of fish detection for optimizing fishing techniques in such environments. Here, we investigate the potential of electrical impedance spectroscopy as a remote sensing technique for fish detection, to address this issue. The approach utilizes a set of electrodes to generate a low-intensity alternating electric current through water, and to measure the impedance. We conducted a number of experiments in which a fish was swimming in a glass tank. We measured changes in impedance at different frequencies, using different electrode arrangements, while simultaneously tracking the fish position with a pair of cameras. We also created numerical models of the experimental setup using the finite element method. The results of simulations were compared to the experimental data to test the accuracy of predictions and to determine if such a model could be a useful tool for designing detection setups for specific environmental conditions. We measured the robustness of the system to the presence air bubbles as a potential source of disturbances. Our results show a clear correlation between the observed drops in both real and imaginary parts of the measured impedance and the position of the fish. Model simulations showed qualitatively and quantitively similar results, indicating that such models could be suitable for practical applications.
1 October 2015 in Journal of Vibration and Acoustics
The paper presents the developed algorithm which implements the indirect variational boundary element method (IVBEM) for computation of the free-field acoustic radiation characteristics of vibrating rectangle-shaped plate structures with arbitrary boundary conditions. In order to significantly reduce the computational time and cost, the algorithm takes advantage of simple geometry of the considered problem and symmetries between the elements. The procedure of determining the distribution of acoustic pressure is illustrated on the example of thin, rectangular plate with a part of one edge clamped and all other edges free. The eigenfrequencies and the corresponding vibrational mode shapes of the plate are computed using the finite element method (FEM). The results of the numerical simulations are compared to the results of the experiments carried out in an anechoic chamber, proving good agreement between the predictions and the observations. The reliability of simulations and high computational efficiency make the developed algorithm a useful tool in analysis of the acoustic radiation characteristics of vibrating plate structures.
1 December 2013 in Archives of Acoustics
7 December 2020 in Bioacoustics
Air and water constitute acoustic propagation media with very different physical properties. Consequently, mechanisms for air- and water-borne sound generation observed in terrestrial and aquatic animals are also significantly different. Notwithstanding, some amphibious species are capable of making efficient use of their vocal tracts in both environments. The present study investigates such a phenomenon on the example of grey seals Halichoerus grypus. Grey seals vocalise both underwater and above the water surface emitting variety of sounds. Both kinds of vocalisations were recorded using microphones and hydrophones, and analysed for their acoustic parameters which could be related to the underlying generation mechanisms. Also, video with synchronised underwater audio recordings were captured, allowing to link the acoustic phenomena with specific behaviour of the animals. The vocalisations are categorised into three groups based on differences in acoustic characteristics. Temporal and spectral parameters of the sounds belonging to each group are determined and discussed in terms of potential underlying generation mechanisms. Based on the adopted criteria surface vocalisations do not constitute a separate group but are categorised together with other tonal sounds produced underwater. Other two vocalisation groups include pulsed sounds with different bandwidths, duration times, repetition rates and associated behavioural signatures.