Soft materials tend to be highly permeable to gases, making it difficult to create stretchable hermetic seals. With the integration of spacers, we demonstrate the use of liquid metals, which show both metallic and fluidic properties, as stretchable hermetic seals. Such soft seals are used in both a stretchable battery and a stretchable heat transfer system that involve volatile fluids, including water and organic fluids. The capacity retention of the battery was ~72.5% after 500 cycles, and the sealed heat transfer system showed an increased thermal conductivity of approximately 309 watts per meter-kelvin while strained and heated. Furthermore, with the incorporation of a signal transmission window, we demonstrated wireless communication through such seals. This work provides a route to create stretchable yet hermetic packaging design solutions for soft devices.
Pastes and “foams” containing liquid metal (LM) as the continuous phase (liquid metal foams, LMFs) exhibit metallic properties while displaying paste or putty‐like rheological behavior. These properties enable LMFs to be patterned into soft and stretchable electrical and thermal conductors through processes conducted at room temperature, such as printing. The simplest LMFs, featured in this work, are made by stirring LM in air, thereby entraining oxide‐lined air “pockets” into the LM. Here, it is reported that mixing small amounts of water (as low as 1 wt%) into such LMFs gives rise to significant foaming by harnessing known reactions that evolve hydrogen and produce oxides. The resulting structures can be ≈4–5× their original volume and possess a fascinating combination of attributes: porosity, electrical conductivity, and responsiveness to environmental conditions. This expansion can be utilized for a type of 4D printing in which patterned conductors “grow,” fill cavities, and change shape and density with respect to time. Excessive exposure to water in the long term ultimately consumes the metal in the LMF. However, when exposure to water is controlled, the metallic properties of porous LMFs can be preserved.
Ga‐based liquid metals (LMs) are conductive liquids in room conditions, making them attractive for printing conductive patterns. Yet, LM extrudes as droplets because of its high effective interfacial tension and low viscosity. In contrast, liquid metal foams (LMFs) exhibit yield stress and shear‐thinning behavior, which are necessary for extruding filaments for direct ink writing (DIW). LMFs are made by stirring LM in air, thereby entraining oxide‐lined air capsules. Unlike LM mixtures containing metallic particles, LMFs do not embrittle from intermetallic phase formation. Here, DIW of LMF and the challenge of separation of dissimilar phases during extrusion are explored. Incorporating additives, glycerol and tannic acid (TA), into LMF improves the printability of the mixture. The new formulations, LMFG (LMF + glycerol) and LMFGT (LMF + TA‐glycerol solution), extrude more uniformly and produce better print quality than LMF. Interestingly, the viscosity and flow stress of LMF is between that of LMFGT and LMFG. This highlights the limitation of relying on rheological properties alone to predict printability in the case of LMF‐based mixtures. With LM as the continuous phase, these LMF‐based inks exhibit high electrical conductivity. DIW of LMF‐based inks can be done in room conditions without additional pre/ post‐processing, among other advantages.
To quantify how the viscosities of silicone oil (SO) and liquid metal (LM) relate to emulsion-formation (LM-in-SO versus SO-in-LM), a process was developed to produce LM pastes with adjustable viscosity and minimal oxide and bubbles. Increased LM viscosity allows greater silicone oil intake and/or intake of higher-viscosity silicone oils.