1 October 2018 in IEEE Transactions on Power Electronics
SiC mosfet s allow a higher frequency, lighter weight inverter over their Si counterparts for electric vehicle (EV) applications. However, using SiC-based EV traction inverters is likely to increase the shaft voltage in an ac motor drive system, which significantly affects the reliability of the system. This paper investigates the impact of high-speed switching of SiC devices and high switching frequency of SiC-based inverter on the common-mode voltage (CMV) and the shaft voltage. It is theoretically illustrated and experimentally demonstrated that the high switching frequency increases the amplitude of the shaft voltage, while the fast switching speed has limited influence on both CMV and the shaft voltage. Afterward, active zero state pulsewidth modulation (AZSPWM) and common-mode chokes are employed to mitigate the shaft voltage. The experimental results show that either the AZSPWM modulation scheme or common-mode chokes have the capability to minimize the shaft voltage. Better performance can be achieved by utilizing both techniques simultaneously. It is also observed that the high switching frequency enabled by the fast-speed SiC device is able to be helpful to the use of reduced shaft voltage technologies.
2 July 2018 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This paper presents a novel open-loop gate control of the turn-on transient for SiC MOSFETs in hard switching conditions. The gate control could reduce the SiC MOSFETs turn-on gate voltage overshoot and control turn-on di/dt and dv/dt independently. Because of the high turn-on speed, SiC MOSFETs bring serious electromagnetic interference (EMI) in the half-bridge topology. A conventional gate driver decreases EMI by increasing the gate resistor, but clearly increasing the turn-on loss. To address this tradeoff and optimize SiC MOSFETs turn-on transition, the drain current slope and the drain-source voltage slope are controlled independently by controlling the gate-source voltage profile during the current rise phase and the gate current during the voltage falling phase. In addition, gate voltage overshoot is considered and discussed. By adding a considerably higher gate resistance during the on-state operation stage, gate voltage overshoot is almost non-existent while maintaining low turn-on loss. Experimental verifications of the proposed approach are finally conducted, and the advantages of proposed driver are analyzed and discussed.