13 February 2020 in Nano Research
In this work, Raman measurements of 1–5-layer WSe2 supported on SiO2/Si in the temperature range of 133 to 533 K are reported. A physical model including both volume effect and temperature effect is used to quantitatively understand the nonlinear temperature dependence of E2g1 Raman mode. It is found this nonlinear dependence of Raman mode mainly originates from thermal expansion effect and three-phonon scattering. The former effect increases with an increase in number of layers, which is inverse for the latter effect. The temperature-dependent thermal expansion coefficients of 1–5-layer WSe2 are also obtained from Raman spectra. The full width at half maximum (FWHM) of E2g1 mode is also systematically studied both experimentally and theoretically in the temperature range of 133 to 413 K. It is found that the increase in FWHM of E2g1 mode originates from decaying of E2g1 phonon. This work will promote the understanding of anharmonic behaviors of phonons in WSe2 flakes with different thicknesses.
9 October 2019 in Nanoscale
The quantitative understanding of birefringence and dichroism in ReS2 flakes can be obtained from angle-resolved polarized optical contrast spectroscopy.
9 March 2020 in Journal of Applied Physics
Atomically thin molybdenum disulfide (MoS2) has attracted significant research interest due to its unique properties, e.g., large on/off ratio, moderate bandgap, and ultralow standby power dissipation, which offer the potential for advanced devices. Interfacial thermal transport significantly affects the heat removal abilities of the devices, thus influencing the thermal stability of the devices. In this work, high thermal conductivity material graphene is used as a supporting substrate for MoS2 to improve heat dissipation in devices based on MoS2. Combining temperature- and laser power-dependent Raman spectroscopy studies, interfacial thermal conductance (g) of five-layer MoS2 supported on SiO2/Si and three-layer graphene substrates are obtained, which are 1.73 ± 0.07 MW m−2 K−1 and 2.56 ± 0.08 MW m−2 K−1, respectively. It is found that a 47.9% increase of g for MoS2 was supported by graphene. Using the high thermal conductivity material graphene as a supporting substrate for MoS2, therefore, opens up another channel for conducting heat, and this dramatically increases the thermal stability of the devices based on MoS2. Our results shed light on experimentally probing interfacial thermal conductance between MoS2 flakes and different supported substrates.
7 January 2022 in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
1 June 2020 in Journal of Applied Physics
In this work, homogeneous surface oxidation of hafnium disulfide (HfS2) is achieved by an extremely simple thermal treatment, i.e., mild oxidization in air. Due to the high thermal stability of hafnium dioxide (HfO2), atomically flat HfO2 is formed on top of unoxidized HfS2 and unlimited layer-by-layer oxidation is observed. The thickness of HfO2 can be controlled by oxidation temperature and time. The HfO2 layer fabricated by the oxidation of HfS2 is smooth and atomically flat with roughness comparable to that of pristine HfS2. Growth of a high-quality, uniform, atomically flat oxide film on top of semiconductor is the first step for the fabrication of field effect transistors and metal-insulator-semiconductor devices. Thus, our results will facilitate the future fabrication of HfO2 films with atomic-scale thickness.