1 April 2006 in Journal of Electromyography and Kinesiology
1 August 2013 in Journal of Electromyography and Kinesiology
1 December 2005 in Clinical Biomechanics
1 June 2006 in Journal of Manipulative and Physiological Therapeutics
Only a few abdominal muscle exercises have been quantitatively evaluated on both a mat and exercise ball, but the benefits reported for the ball have been equivocally applied to all exercises. The purpose of this study is to evaluate differences in the biological response of muscle activation, lumbar spine posture, and loading variables for extensor exercises performed on 2 surfaces. Bilateral muscle activation was recorded from 7 sites (rectus abdominis, external/internal obliques, latissimus dorsi, thoracic/lumbar erector spinae, and multifidus) on 8 subjects. Three-dimensional lumbar spine postures and upper body kinematics were recorded while the participants performed the exercises. An electromyography-driven model was used to calculate spinal loading. Cocontraction of trunk flexor and extensor muscles was reduced by up to 30% for the extension exercises when performed on the ball. Peak muscle activation remained unchanged or decreased, and spinal loading (compression and anterior-posterior shear) decreased when the extension exercises were performed on the ball. The lumbar spine postures attained during the exercises did not differ between surfaces. The assumption that the use of an exercise ball will always create a greater challenge for the musculoskeletal system was not supported by the findings of this study. Likewise, in a healthy, young population, there does not appear to be any training advantage to performing extensor exercises on a ball versus a mat. However, in a rehabilitation scenario, these exercises performed on a ball could reduce low back loading and hence reduce the potential for reinjury.
1 July 2013 in Journal of Manipulative and Physiological Therapeutics
There are various methods to quantify the flexion-relaxation phenomenon (FRP); however, there is little standardization. This study aimed to evaluate the performance of various quantification methods in terms of their ability to identify lumbar erector spinae flexion-relaxation during standing forward trunk flexion. The study was a cross-sectional design in a laboratory setting. Lumbar erector spinae activation levels were measured in 12 male participants performing full trunk flexion movements. Electromyographical signals were assessed using 16 criteria within 4 quantification methods (visual, statistical, threshold, ratio), and the sensitivity of each was assessed relative to the benchmark criterion (visual inspection of raw electromyography data). Visual inspection and most of the threshold and ratio criteria displayed the highest sensitivity. On average (SD) across the 16 criteria, FRP was positively identified 21.6 (6.2) times of 24 data sets (12 participants, 2 muscles). The visual inspection criteria positively identified FRP in all 24 trials, whereas the statistical method did not identify FRP at all (P = .44 and P = .46 for the left and right sides, respectively). The threshold and ratio criteria positively identified FRP 23.2 (1.5) and 22.5 (3.7) times, on average, respectively. Results from criteria based on differences between upright and fully flexed muscle activation tended to be conservative in FRP identification. The methods were classified as reliable or nonreliable, based on their sensitivity when specific characteristics were evident in the electromyography signals. Although many of the criteria identified FRP with 100% sensitivity, others produced unrealistic results. The latter may be suitable for other experimental designs or may require reevaluation regarding their ability to identify FRP. Although visual inspection, threshold, or ratio methods performed well and may be appropriate for either biomechanical or clinical research, the threshold method provided the optimal trade-off between performance, consistency, and feasibility for these data.