2 December 2010 in Journal of Synchrotron Radiation
Phosphorus K-edge X-ray absorption near-edge structure (XANES) spectroscopy was performed on phosphate mineral specimens including (a) twelve specimens from the apatite group covering a range of compositional variation and crystallinity; (b) six non-apatite calcium-rich phosphate minerals; (c) 15 aluminium-rich phosphate minerals; (d) ten phosphate minerals rich in either reduced iron or manganese; (e) four phosphate minerals rich in either oxidized iron or manganese; (f) eight phosphate minerals rich in either magnesium, copper, lead, zinc or rare-earth elements; and (g) four uranium phosphate minerals. The identity of all minerals examined in this study was independently confirmed using X-ray powder diffraction. Minerals were distinguished using XANES spectra with a combination of pre-edge features, edge position, peak shapes and post-edge features. Shared spectral features were observed in minerals with compositions dominated by the same specific cation. Analyses of apatite-group minerals indicate that XANES spectral patterns are not strongly affected by variations in composition and crystallinity typical of natural mineral specimens.
1 November 2011 in Geochimica et Cosmochimica Acta
10 February 2012 in Environmental Science & Technology
11 May 2015 in The Journal of Physical Chemistry A
28 February 1996 in Clays and Clay Minerals
Three different models have been reported previously to describe the kinetics of the transformation of smectite to illite (Pytte 1982; Velde and Vasseur 1992; Huang et al. 1993). In order to evaluate the general utility of these models to calculate the timing and extent of this transformation, each model was applied to four different geologic settings (Denver Basin, Gulf Coast, the Salton Sea Geothermal System, and Paris Basin) in which the ages, geothermal gradients and potassium ion activities vary markedly. The model results are compared to the measured percentages of illite in illite/smectite (I/S) and the K/Ar ages of I/S (if available) to test the utility of a given model to a particular basin.Although individual models can be applied to study this transformation within a specific setting, none of these models was successful in simulating the transformation for all four basins. The Salton Sea was simulated best using the model by Huang et al. (1993), which incorporated an increased geothermal gradient during the last 20,000 years. These results indicate that a large fraction of illite formed due to this increased geothermal gradient, and underscores that temperature is a dominant kinetic factor in forming illite. The Denver Basin was simulated well by the models of Velde and Vasseur (1992) and Pytte (1982). The Gulf Coast was simulated very well by the model of Huang et al. (1993) using a term that terminates the transformation at 75% illite. For the Paris Basin, the results are mixed. The models can be refined by comparing the calculated and measured ages of illite such as the K/Ar ages of I/S to understand the thermal history of a particular basin. The calculated ages of illitization derived from these refined models can be used to indicate the time at which source rocks became thermally mature to form oil and gas.
1 January 2008 in Applied and Environmental Microbiology
Recent studies have suggested that the structural Fe(III) within phyllosilicate minerals, including smectite and illite, is an important electron acceptor for Fe(III)-reducing microorganisms in sedimentary environments at moderate temperatures. The reduction of structural Fe(III) by thermophiles, however, has not previously been described. A wide range of thermophilic and hyperthermophilicArchaeaandBacteriafrom marine and freshwater environments that are known to reduce poorly crystalline Fe(III) oxides were tested for their ability to reduce structural (octahedrally coordinated) Fe(III) in smectite (SWa-1) as the sole electron acceptor. Two out of the 10 organisms tested,Geoglobus ahangariandGeothermobacterium ferrireducens, were not able to conserve energy to support growth by reduction of Fe(III) in SWa-1 despite the fact that both organisms were originally isolated with solid-phase Fe(III) as the electron acceptor. The other organisms tested were able to grow on SWa-1 and reduced 6.3 to 15.1% of the Fe(III). This is 20 to 50% less than the reported amounts of Fe(III) reduced in the same smectite (SWa-1) by mesophilic Fe(III) reducers. Two organisms,Geothermobacter ehrlichiiand archaeal strain 140, produced copious amounts of an exopolysaccharide material, which may have played an active role in the dissolution of the structural iron in SWa-1 smectite. The reduction of structural Fe(III) in SWa-1 by archaeal strain 140 was studied in detail. Microbial Fe(III) reduction was accompanied by an increase in interlayer and octahedral charges and some incorporation of potassium and magnesium into the smectite structure. However, these changes in the major element chemistry of SWa-1 smectite did not result in the formation of an illite-like structure, as reported for a mesophilic Fe(III) reducer. These results suggest that thermophilic Fe(III)-reducing organisms differ in their ability to reduce and solubilize structural Fe(III) in SWa-1 smectite and that SWa-1 is not easily transformed to illite by these organisms.