Temperature coefficients for maximum power (TPCE), open circuit voltage (VOC), and short circuit current (JSC) are standard specifications included in data sheets for any commercially available photovoltaic module. To date, there has been little work on determining the TPCE for perovskite photovoltaics (PV). We fabricate perovskite solar cells with a TPCE of −0.08 rel %/°C and then disentangle the temperature-dependent effects of the perovskite absorber, contact layers, and interfaces by comparing different device architectures and using drift-diffusion modeling. A main factor contributing to the small TPCE of perovskites is their low intrinsic carrier concentrations with respect to Si and GaAs, which can be explained by its wider band gap. We demonstrate that the unique increase in Eg with increasing temperatures seen for perovskites results in a reduction in JSC but positively influences VOC. The current limiting factors for the TPCE in perovskite PV are identified to originate from interfacial effects.
The authors investigate how chiral ligands attached to perovskite nanocrystal (PNC) surfaces structurally distort the perovskite lattice. Chiral electro‐optical properties of the resulting PNCs are demonstrated through the fabrication of a circularly polarized light (CPL) detector with a discrimination of up to 14% between left‐ and right‐handed CPL. Both experimental and electronic‐structure‐based simulations are combined to provide insights into the interactions (both structural and electronic) between chiral organic ligands and PNCs. The major finding is a centro‐asymmetric distortion of the surface lattice that penetrates up to five atomic unit cells deep into the PNCs, which is the likely cause of the chiral‐optical properties. Spin‐polarized transport through chiral‐PNCs results from the chiral‐induced spin selectivity effect and amplifies the discrimination between left and right‐handed CPL as is experimentally demonstrated in the detectors.
Perovskite quantum dots (PQDs) have many properties that make them attractive for optoelectronic applications, including expanded compositional tunability and crystallographic stabilization. While they have not achieved the same photovoltaic (PV) efficiencies of top-performing perovskite thin films, they do reproducibly show high open circuit voltage (VOC) in comparison. Further understanding of the VOC attainable in PQDs as a function of surface passivation, contact layers, and PQD composition will further progress the field and may lend useful lessons for non-QD perovskite solar cells. Here, we use photoluminescence-based spectroscopic techniques to understand and identify the governing physics of the VOC in CsPbI3 PQDs. In particular, we probe the effect of the ligand exchange and contact interfaces on the VOC and free charge carrier concentration. The free charge carrier concentration is orders of magnitude higher than in typical perovskite thin films and could be tunable through ligand chemistry. Tuning the PQD A-site cation composition via replacement of Cs+ with FA+ maintains the background carrier concentration but reduces the trap density by up to a factor of 40, reducing the VOC deficit. These results dictate how to improve PQD optoelectronic properties and PV device performance and explain the reduced interfacial recombination observed by coupling PQDs with thin-film perovskites for a hybrid absorber layer.