28 August 2024 in Environmental Science and Pollution Research
Obtaining value-added products from renewable resources is limited by the lack of specific operating conditions optimized for the physico-chemical characteristics of the biomass and the desired end product. A mathematical model and statistical optimization were developed for the production of volatile fatty acids (VFAs) by anaerobic digestion of municipal sewage sludge. The experimental tests were carried out in triplicate and investigated a wide range of conditions: pH 9.5, 10.5, and 11.5; temperatures 25 °C, 35 °C, 45 °C, and 55 °C; primary sludge with organic loading (OL) of 10 and 14 g VS (volatile solids); and digested sludge with 4 and 6 g VS. Subsequently, a statistical search was performed to obtain optimal production conditions, then a statistical model of VFA production was developed and the optimal conditions were validated at pilot plant scale. The maximum VFA concentration predicted was 6975 mg COD (chemical oxygen demand)/L using primary sludge at 25 °C, initial OL of 14 g VS, and pH 10.5. The obtained third-degree model ( r 2 = 0.83) is a powerful tool for bioprocess scale-up, offering a promising avenue for sustainable waste management and biorefinery development.
11 April 2024 in Cogent Engineering
21 March 2025 in SN Computer Science
This paper presents the development of a temperature model, based on the energy balance of a semi-continuous reactor consisting of 3 stainless steel digesters of 6L each, operating at temperatures from 25 to 75 °C, with stirrer, gas sampling points and pH and temperature control panels; in addition, the reactors depend on the ambient temperature and the input power. This model is intended to predict the thermal behaviour of the reactor. The variables that are not independent are estimated from three methods, the method of least squares with a static model, the method of least squares with a dynamic model and the method of nonlinear least squares with dynamic model and additional delay, the last one presents a new dynamic with respect to the original model. For the estimation of variables and subsequent comparison between methods, data were taken from the reactor in operation for 4 days. As a result, it was possible to estimate the reactor temperature with a maximum error of approximately one degree Celsius, where it is obtained that the best model is the least squares method with a static model. This pilot-scale work generates contributions to the challenge of improving energy efficiency in biogas production models, or value-added products such as volatile fatty acids, through Anaerobic Digestion (AD) considering that this is one of the conditions to be evaluated in industrial scale-up processes.
10 April 2025 in Waste and Biomass Valorization
To better understand the anaerobic digestion process, models can be made based on already performed fermentations, however, these models are limited in the literature. In this contribution, a model was developed based on the modified Hill model, which can predict the production of volatile fatty acids. The model used eight differential equations reported by Haugen who is based on the modified Hill model and four state variables, using MATLAB. This model can predict the production of volatile fatty acids in both semi-continuous and batch processes, using substrates digested sludge and primary sludge from a Wastewater Treatment Plant under different conditions such as organic load, temperature, pH, and hydraulic retention time. The deviation between the experiments performed and the model developed was less than ± 9.1%, demonstrating this model’s accuracy and robustness. Furthermore, the statistical analysis showed that there were no significant differences between the fermentations and the simulation, verifying the null hypothesis. The developed model identified a stable and optimal VFA-generating loading rate from experimental data. Graphical Abstract
5 May 2026 in Environmental Science and Pollution Research
Polyhydroxyalkanoates (PHAs) are biodegradable biobased polymers with the potential to replace conventional plastics. To reduce production costs while contributing to wastewater treatment, mixed microbial cultures (MMCs) have been proposed as a sustainable platform for PHA production. This process comprises three stages: (1) acidogenic fermentation of wastewater streams to generate volatile fatty acids (VFAs), (2) selection and enrichment of MMCs under feast–famine conditions, and (3) PHA accumulation using the selected biomass. The aim of this study was to evaluate the selection and enrichment of MMCs for PHA production within a circular economy framework. VFAs obtained by sludge acidogenic fermentation were used as the carbon source, and two operational factors organic load (500–1500 mg COD L -1 ) and cycle length (3 or 6 days) were tested in a $$3 \times 2$$ factorial design. The condition of 500 mg COD L -1 with a 3-day cycle achieved the highest performance, with statistically significant effects ( p < 0.05) for both main factors and their interaction. Pilot-scale validation in a 16-L working volume reactor confirmed these results, yielding 83.3 mg PHA L -1 (reported as PHB-equivalents following acid hydrolysis to crotonic acid and HPLC quantification) and a yield of 0.28 g COD g COD -1 ( $$Y_{PHA/VFA}$$ , expressed as COD-based PHA produced per COD of VFA consumed). Molecular analysis revealed species classically associated with PHA dynamics ( Paracoccus sp., Alcaligenes sp.) and the presence of Diaphorobacter limosus , suggesting complementary roles under selective pressure. These findings highlight wastewater valorization into bioplastics as a viable route within the circular economy framework. Graphical