Jan Grahn

Jan Grahn

Auto-generated profile, based on publicly available information

Jan Grahn

Chalmers University of Technology

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 June 2020 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
ECEunjung Cha
Eunjung Cha
NWNiklas Wadefalk
Niklas Wadefalk
GMGiuseppe Moschetti
Giuseppe Moschetti
APArsalan Pourkabirian
Arsalan Pourkabirian
JSJorgen Stenarson
Jorgen Stenarson
JGJan Grahn
Jan Grahn

19 October 2018 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
ECEunjung Cha
Eunjung Cha
NWNiklas Wadefalk
Niklas Wadefalk
PNPer-Ake Nilsson
Per-Ake Nilsson
JSJoel Schleeh
Joel Schleeh
GMGiuseppe Moschetti
Giuseppe Moschetti
JGJan Grahn
Jan Grahn
We present two monolithic microwave integrated circuit (MMIC) cryogenic broadband low-noise amplifiers (LNAs) based on the 100 nm gate length InP high-electron mobility transistor technology for the frequency range of 0.3-14 and 16-28 GHz. The 0.3-14 GHz three-stage LNA exhibited a gain of 41.6 ± 1.4 dB and an average noise temperature of 3.5 K with a minimum noise temperature of 2.2 K at 6 GHz when cooled down to 4 K. The 16-28 GHz three-stage LNA showed a gain of 32.3 ± 1.8 dB and an average noise temperature of 6.3 K with a minimum noise temperature of 4.8 K at 20.8 GHz at the ambient temperature of 4 K. This is the first demonstration of cryogenic MMIC LNA covering the whole K-band. To the best of the authors' knowledge, the cryogenic MMIC LNAs demonstrated the state-of-the-art noise performance in the 0.3-14 and 16-28 GHz frequency range.

18 November 2008 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
MMMikael Malmkvist
Mikael Malmkvist
ELEric Lefebvre
Eric Lefebvre
MBMalin Borg
Malin Borg
LDLudovic Desplanque
Ludovic Desplanque
XWXavier Wallart
Xavier Wallart
JGJan Grahn
Jan Grahn
Electrical characterization and modeling of 2 times 50 mum gatewidth InAs/AlSb HEMTs with 225 nm gate-length have been performed. The fabricated devices exhibited a transconductance gm of 650 mS/mm, an extrinsic cutoff frequency fT and an extrinsic maximum frequency of oscillation fmax of 120 and 90 GHz, respectively, already at a low VDS of 0.2 V. A minimum noise figure less than 1 dB between 2-18 GHz was achieved at a dc power consumption of only 10 mW/mm. This demonstrates the potential of InAs/AlSb HEMTs for low-power, low-noise applications. To account for the elevated gate-leakage current lG in the narrow-bandgap InAs/AlSb HEMT, the conventional field-effect transistor small-signal model has been extended. The relatively high IG was modeled by shunting both Cgs and Cgd with Rgs and .Rgd, respectively. As a result, the small-signal S-parameters were more accurately modeled, especially for frequencies below 10 GHz. Utilizing this modeling approach, excellent agreement was obtained between measured and modeled S-parameters, unilateral power gain U (Mason's gain) and stability factor K.

14 March 2023 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ECEunjung Cha
Eunjung Cha
NWNiklas Wadefalk
Niklas Wadefalk
GMGiuseppe Moschetti
Giuseppe Moschetti
APArsalan Pourkabirian
Arsalan Pourkabirian
JSJörgen Stenarson
Jörgen Stenarson
JGJan Grahn
Jan Grahn
We report the impact from channel composition on the cryogenic low-noise performance at low dc power for a 100-nm gate-length InGaAs-InAlAs-InP high-electron mobility transistor (HEMT). Two indium (In) channel compositions, 65% and 80%, were studied by dc and RF characterization at 300 and 5 K. For the cryogenic low-noise optimization, it was important to increase the transconductance to gate–source capacitance ratio in the weak inversion region implying that a higher maximum cutoff frequency in the HEMT does not guarantee lower noise. The HEMT noise performance was obtained from noise measurements in a hybrid three-stage 4–8-GHz ( ${C}$ -band) low-noise amplifier (LNA) down to 300- $\mu \text{W}$ dc power dissipation. While the HEMT LNA noise performance for both the channel compositions at 300 K was found to be comparable, the HEMT LNA at 5 K with 65% In channel showed a minimum noise temperature of 1.4 K, whereas the noise temperature in the HEMT LNA with 80% In channel HEMTs increased to 2.4 K. The difference in the noise became more pronounced at reduced dc power dissipation. The ultralow dc power of $300 \mu \text{W}$ demonstrated for a cryogenic ${C}$ -band LNA with an average noise temperature of 2.9 K and 24-dB gain is of interest for future qubit read-out electronics at 4 K.

10 November 2017 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
ECEunjung Cha
Eunjung Cha
GMGiuseppe Moschetti
Giuseppe Moschetti
NWNiklas Wadefalk
Niklas Wadefalk
PNPer-Ake Nilsson
Per-Ake Nilsson
SBStella Bevilacqua
Stella Bevilacqua
JGJan Grahn
Jan Grahn
We investigate the cryogenic stability of two-finger 100-nm gate-length InP HEMTs aimed for Ka- and Q-band ultra-low noise amplifiers (LNAs). InP HEMTs with unit gate widths ranging between 30 and 50 $\mu \text{m}$ exhibit unstable cryogenic behavior with jumps in drain current and discontinuous peaks in transconductance. We also find that shorter gate length enhances the cryogenic instability. We demonstrate that the instability of two-finger transistors can be suppressed by either adding a source air bridge, connecting the back end of gates, or increasing the gate resistance. A three-stage 24–40 GHz and a four-stage 28–52-GHz monolithic microwave-integrated circuit LNA using the stabilized InP HEMTs are presented. The Ka-band amplifier achieves a minimum noise temperature of 7 K at 25.6 GHz with an average noise temperature of 10.6 K at an ambient temperature of 5.5 K. The amplifier gain is 29 dB ± 0.6 dB. The Q-band amplifier exhibits minimum noise temperature of 6.7 K at 32.8 GHz with average noise temperature of 10 K at ambient temperature of 5.5 K. The amplifier gain is 34 dB ± 0.8 dB. To our knowledge, the Ka- and Q-band amplifiers demonstrate the lowest noise temperature reported so far for InP cryogenic LNAs.

15 September 2023 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Open access
YZYin Zeng
Yin Zeng
JSJörgen Stenarson
Jörgen Stenarson
PSPeter Sobis
Peter Sobis
NWNiklas Wadefalk
Niklas Wadefalk
JGJan Grahn
Jan Grahn
The cryogenic indium phosphide (InP) high-electron-mobility transistor (HEMT) low-noise amplifier (LNA) is used for the readout amplification of qubits at $4$ K where cooling capabilities are limited implying that the dc power of the active circuits is an essential design constraint. In this article, the RF and noise performance of the InP HEMT under ultralow-power (ULP) operation at $4$ K has been characterized. The small-signal and noise parameter model of the InP HEMT was extracted down to 1 $\mu$ W. The tradeoff between noise performance and dc power consumption was analyzed in terms of the drain current and drain voltage. A 4–6 GHz hybrid cryogenic HEMT LNA designed for qubit readout and optimized for lowest noise below $1$ mW dc power consumption was fabricated. The measured performance of the LNA at $4$ K attained 23.1 dB average gain and 2.0 K average noise temperature at 200 $\mu$ W dc power.