The direct synthesis of hydrogen peroxide using supported gold palladium catalysts prepared by incipient wetness impregnation is described and discussed. The effect of an acid pre-treatment step on the activated carbon support prior to the deposition of the metals, together with the effect of the calcination temperature, has been investigated. The acid pre-treated samples all show superior activity to those materials prepared with the omission of this acid pre-treatment stage. The calcination temperature affects both the re-usability and hydrogenation activity of the catalysts. Detailed characterisation using X-ray photoelectron spectroscopy and aberration-corrected scanning transmission electron microscopy is described. The enhanced activity is associated with a higher surface concentration of palladium in the acid pre-treated samples which is principally present as Pd2+. Calcination of the catalysts at 400°C is required to achieve re-usable and stable catalysts, and this is associated with the morphology and dispersion of the metal nanoparticles. The surface ratio of Pd0/Pd2+ is found to be an important factor controlling the hydrogenation of hydrogen peroxide, and a series of controlled reduction and re-oxidation of a sample show how the Pd0/Pd2+ surface ratio can influence the relative rates of hydrogen peroxide synthesis and hydrogenation
Catalysts were prepared by impregnation-based method involving excess Cl− anion addition to the metal chloride precursors which resulted in improved mixing of metals and led to formation of highly ordered PdZn alloys responsible for high catalytic selectivity.
Zincian georgeite, an amorphous copper–zinc hydroxycarbonate, has been prepared by co-precipitation using acetate salts and ammonium carbonate. Incorporation of zinc into the georgeite phase and mild ageing conditions inhibits crystallisation into zincian malachite or aurichalcite. This zincian georgeite precursor was used to prepare a Cu/ZnO catalyst, which exhibits a superior performance to a zincian malachite derived catalyst for methanol synthesis and the low temperature water–gas shift (LTS) reaction. Furthermore, the enhanced LTS activity and stability in comparison to that of a commercial Cu/ZnO/Al2O3 catalyst, indicates that the addition of alumina as a stabiliser may not be required for the zincian georgeite derived Cu/ZnO catalyst. The enhanced performance is partly attributed to the exclusion of alkali metals from the synthesis procedure, which are known to act as catalyst poisons. The effect of residual sodium on the microstructural properties of the catalyst precursor was investigated further from preparations using sodium carbonate.