24 June 2019 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a fully integrated silicon-germanium (SiGe)-based compact high-resolution frequency-modulated continuous-wave (FMCW) radar sensor working in a frequency range from 198 to 250 GHz is presented. The wide modulation bandwidth of 52 GHz enables a range resolution better than 3 mm combined with a measurement accuracy in the micrometer regime. Together with a low power consumption of approximately 3.5 W, a high-focusing Teflon lens antenna, and a compact and robust housing, the presented radar system is capable of satisfying the needs of several novel measuring tasks. A compensated measurement accuracy of down to -0.5-0.4 μm is achieved, which is demonstrated by distance measurements using a laser interferometer reference. Additionally, a calibration technique is shown enabling multi-target measurements reaching to the theoretical limit of the range resolution. As the fundamental feedthrough of common frequency doubler architectures cause false targets in the range profile, a dielectric fundamental frequency filter is presented as well, filtering the fundamental feedthrough signal and thus removing the false target, improving the unambiguousness of the presented radar sensor.
8 January 2020 in IEEE Transactions on Microwave Theory and Techniques
Airborne applications demand exceptional overall radar system performance and eminently high output power for high range target detection. The frequency modulated continuous wave (FMCW) radar system presented in this article is capable of achieving this task due to its high output power at 94-GHz center frequency with over 26-GHz tuning range. Nevertheless, the radar still provides a small form factor and low power consumption of 4.25 W at 5 V single Universal Serial Bus (USB) supply. The key system component is a Silicon Germanium (SiGe) bipolar complementary metal-oxide-semiconductor (BiCMOS) monolithic microwave integrated circuit (MMIC) that contains a 94-GHz voltage-controlled oscillator (VCO), and a 27-GHz VCO for dual-loop phase-locked loop (PLL) stabilization, a power amplifier (PA), and two receive mixers. It generates frequency ramps between 83- and 109-GHz with a maximum output power of 19.7 dBm at its output after the bond wires on the printed circuit board (PCB) and 14.8-dBm output power at the radar's transmit (TX)-waveguide WR-10-flange. The sensor was also tested in a temperature range from -40 °C to +70 °C with menial deviation. Thus, the system offers high system dynamic range and far distance target detection range. Following a detailed system description, we finally present the FMCW range and Doppler measurements performed with the presented radar sensor as well as the application on unmanned aerial vehicles (UAVs) for flight altitude control and as airborne collision avoidance system (ACAS).
13 March 2024 in IEEE Journal of Microwaves
This article compares two SiGe Colpitts quadrature voltage-controlled oscillators (QVCO) with different coupling techniques in the low E-Band, intended to be used as signal sources for push-push frequency doublers. The first QVCO is based on a cross-coupled tail-current topology, while the second is based on a fundamental active coupling network. The cross-coupled QVCO has a center frequency of 64.3 GHz and a bandwidth of 2.5 GHz. This circuit realization provides up to 12.2 dBm output power per channel and has a power consumption of 385 mW, resulting in a dc-to-RF efficiency of 8.6%. The phase noise of this oscillator at 1 MHz offset frequency is as low as −105 dBc/Hz. The fundamentally coupled QVCO has a center frequency of 67 GHz with a bandwidth of 3.9 GHz. It provides 13.1 dBm output power per channel while consuming 410 mW of power, resulting in a dc-to-RF efficiency of 9.9%. The oscillator's phase noise at 1 MHz offset frequency is as low as −105.2 dBc/Hz. In addition to the presented circuits, this article introduces a method to measure the relative phase error of quadrature signals utilizing a vector network analyzer. This method is verified with measurements of the developed QVCOs.
26 October 2022 in International Journal of Microwave and Wireless Technologies
Modern radar sensors are gaining more and more relevance for several industrial measurement applications. To achieve the required range resolution and measurement accuracy, the use of higher frequencies beyond 100 GHz is beneficiary. A commonly used signal generation concept in fully integrated radar transceivers is to use a fundamental oscillator with subsequent frequency multiplication. Depending on the overall system concept, this type of signal generation suffers from a fundamental feed-through signal which generates false targets in frequency modulated continuous wave operation. Additionally, those unwanted signal components radiated by the sensors might be problematic for legal conformity or electromagnetic (EM) interference compliance. This paper presents a novel concept for frequency filtering dielectric lens antennas, to suppress unwanted signal components at harmonic frequencies based on interference filtering effects. Besides the EM simulations to theoretically prove this concept, multiple prototypes of filtering lens antennas were fabricated by conventional mechanical and additive manufacturing. Using a self-developed, ultra-compact radar sensor, measurements were taken to compare the lens antenna prototypes in terms of filtering performance and how the material characteristics affect the filtering performance. Within these measurements, the successful suppression of false targets caused by fundamental feed-through signals is demonstrated.