Lang Shen

Lang Shen

Auto-generated profile, based on publicly available information

Lang Shen

Mork Family Department of Chemical Engineering and Materials Science, University of Southern California 1 , Los Angeles, California 90089, USA

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 September 2015 in ACS Nano
Verified
Journal Article
Closed access
SLSung-Min Lee
Sung-Min Lee
AKAnthony Kwong
Anthony Kwong
DJDaehwan Jung
Daehwan Jung
JFJoseph Faucher
Joseph Faucher
RBRoshni Biswas
Roshni Biswas
JYJongseung Yoon
Jongseung Yoon

5 January 2017 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
BHBingya Hou
Bingya Hou
LSLang Shen
Lang Shen
HSHaotian Shi
Haotian Shi
RKRehan Kapadia
Rehan Kapadia
SCStephen Cronin
Stephen Cronin
We report measurements of photocatalytic water splitting using Au films with and without TiO 2 coatings.

20 August 2018 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
JCJihan Chen
Jihan Chen
Jaehyun KimJaehyun Kim
Jaehyun Kim
NPNirakar Poudel
Nirakar Poudel
BHBingya Hou
Bingya Hou
LSLang Shen
Lang Shen
SCStephen Cronin
Stephen Cronin
We report in-plane thermoelectric measurements of Bi2Te3 nanoplates, a typical topological insulator with Dirac-like metallic surface states, grown by chemical vapor deposition. The as-grown flakes exposed to ambient conditions exhibit relatively small thermopowers around −34 μV/K due to unintentional surface doping (e.g., gas adsorption and surface oxidation). After removal of the unintentional surface doping and surface passivation by deposition of 30 nm of Al2O3 using atomic layer deposition (ALD), the Seebeck coefficient of these flakes increases by a factor of 5× to −169 μV/K. Here, we believe that the ALD-based surface passivation can prevent the degradation of the thermoelectric properties caused by gas adsorption and surface oxidation processes, thus, reducing the unintentional doping in the Bi2Te3 and increasing the Seebeck coefficient. The high surface-to-volume ratio of these thin (∼10 nm thick) nanoplates make them especially sensitive to surface doping, which is a common problem among nanomaterials in general. An increase in the sample resistance is also observed after the ALD process, which is consistent with the decrease in doping.

7 October 2019 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
LSLang Shen
Lang Shen
MMMatthew Mecklenburg
Matthew Mecklenburg
RDRohan Dhall
Rohan Dhall
BRB. C. Regan
B. C. Regan
SCStephen Cronin
Stephen Cronin
Transition metal dichalcogenides such as molybdenum disulfide (MoS2) may see service in the heart of next-generation nanoelectronic devices, where highly localized power dissipation can produce nontrivial temperature gradients over nanometer-scale distances. Here, we demonstrate that MoS2 is a promising target for plasmon energy expansion thermometry (PEET), a high-spatial resolution temperature mapping technique employed in a scanning transmission electron microscope (STEM) equipped with electron energy loss spectroscopy (EELS). We first use a calibrated, commercial MEMS-style TEM sample heater chip to measure the temperature dependence of the MoS2 bulk plasmon. We corroborate the chip's temperature calibration with Raman thermometry and determine the bulk thermal expansion coefficient (TEC) of MoS2 in the temperature range of 300–1100 K. Applying this TEC value to PEET measurements on a suspended MoS2 flake, we map 70–90 K/μm temperature gradients with a submicrometer spatial resolution.

1 March 2012 in Materials Research Bulletin
Verified
Journal Article
Closed access
XZXian Zhang
Xian Zhang
QZQin Zhou
Qin Zhou
WWWeipeng Wang
Weipeng Wang
LSLang Shen
Lang Shen
ZLZhengcao Li
Zhengcao Li
ZZZhengjun Zhang
Zhengjun Zhang

5 January 2018 in Nanoscale
Verified
Journal Article
Closed access
PDF file
HSHaotian Shi
Haotian Shi
NPNirakar Poudel
Nirakar Poudel
BHBingya Hou
Bingya Hou
LSLang Shen
Lang Shen
JCJihan Chen
Jihan Chen
SCStephen Cronin
Stephen Cronin
We report a novel approach to probe the local ion concentration at graphene/water interfaces using in situ Raman spectroscopy. Here, the upshifts observed in the G band Raman mode under applied electrochemical potentials are used to determine the charge density in the graphene sheet. For voltages up to ±0.8 V vs. NHE, we observe substantial upshifts in the G band Raman mode by as much as 19 cm−1, which corresponds to electron and hole carrier densities of 1.4 × 1013 cm−2 and Fermi energy shifts of ±430 meV. The charge density in the graphene electrode is also measured independently using the capacitance–voltage characteristics (i.e., Q = CV), and is found to be consistent with those measured by Raman spectroscopy. From charge neutrality requirements, the ion concentration in solution per unit area must be equal and opposite to the charge density in the graphene electrode. Based on these charge densities, we estimate the local ion concentration as a function of electrochemical potential in both pure DI water and 1 M KCl solutions, which span a pH range from 3.8 to 10.4 for pure DI water and net ion concentrations of ±0.7 mol L−1 for KCl under these applied voltages.