1 June 2017 in Journal of Manufacturing Processes
19 April 2016 in Science and Technology of Welding and Joining
Advanced pulsed current gas metal arc based processes are increasingly attempted for the joining of aluminium alloys and galvanised steel sheets. The bead profile and the thickness of the interfacial Fe–Al intermetallic (IMC) layer significantly influence the failure strength of these joints. Although several experimental studies have examined the nature and extent of the IMC phases and consequent joint strength, quantitative efforts to estimate bead profile and the IMC layer thickness as function of process conditions and resulting heat input are scarce. We present here for the first time a coupled theoretical and experimental study to estimate the bead profile and Fe–Al IMC layer thickness for joining of galvannealed steel and aluminium alloy sheets in a typical lap joint configuration. The computed values of bead profile and IMC layer thicknesses are validated with the corresponding experimental results.
1 May 2015 in Science and Technology of Welding and Joining
Controlling the Fe–Al intermetallic layer thickness along the joint interface has remained a critical challenge in gas metal arc welding of galvanised steel and aluminium alloys. An attempt is presented here to join galvannealed steel and aluminium alloy sheets using a novel gas metal arc welding process that allows controlled short circuiting to reduce the rate of heat input significantly. The real time current and voltage transients during the process are monitored to estimate the rate of heat input and its influence on the formation of intermetallic phases and layer thickness. The results show that the intermetallic layer thickness can be controlled and good joint strengths can be achieved when the rate of heat input remains lesser than 130 J mm− 1 for the typical lap joint configuration considered here.
16 November 2019 in Metals and Materials International
27 November 2019 in The International Journal of Advanced Manufacturing Technology
1 May 2018 in IOP Conference Series: Materials Science and Engineering
Multi-material combination such as aluminium alloys and carbon-fiber-reinforced plastics (CFRP) are increasingly used in the aircraft and automobile industries to enhance strength-to-weight ratio of the respective parts and components. Various processes such as adhesive bonding, mechanical fasteners and laser beam joining were employed to join metal alloy and CFRP sheets. However, long processing time of adhesive bonding, extra weight induced by mechanical fasteners and high operating cost of the laser is major limitations of these processes. Therefore, friction stir welding is an alternative choice to overcome those limitations in joining of CFRP and aluminium alloys. In the present work, an attempt is undertaken to join AA5052 alloy and polyamide 66 CFRP sheets by friction stir lap joining technique using pinned and pin-less tools. The joint qualities are investigated extensively at different joining conditions using two different types of tools and surface ground aluminium sheets. The results show that pin-less tool and surface ground aluminium alloy can provide the suitable joint with maximum joint strength around 8 MPa.