7 February 2023 in Journal of Composite Materials
Morphing wings provide a potential avenue to improve aerodynamic performance of aircraft operating at multiple design conditions. Nevertheless, morphing wing design is constrained by the mutually exclusive goals of high load-carrying capacity, low weight, and sufficient aerodynamic control authority via conformal shape adaptation. This trade-off can be addressed by exploiting the stiffness selectivity and shape “lock-in” properties enabled by using bistable beam-like elements within compliant structures. In this paper, we present an aero-structural optimization method to realize morphing structures with selective stiffness and shape “lock-in” capability from embedded bistable elements. We leverage an embeddable beam element with an invertible curved arch that provides stiffness selectivity and camber variation to the proposed rib geometry. Optimization objectives and constraints are designed to maximize the structure’s stiffness change and camber morphing “lock-in” effect when operating at two distinct flight conditions. Using the optimization results, we manufacture a wing section demonstrator with selective stiffness and “lock-in” morphing featuring two optimized ribs, a load-carrying skin made of a carbon reinforced laminate, Macro-Fiber Composite (MFC) actuators, and a servo-controlled mechanism for switching the bistable elements’ states. The power and energy requirements of actuating and holding a target deflection are experimentally measured and compared. The results show that the bistable elements can assist in holding a target deflection at a reduced energy cost. Finally, we test the experimental demonstrator in a low-speed wind tunnel demonstrating the load carrying capability and lift variation achieved from switching states.
1 October 2024 in Smart Materials and Structures
Piezoelectric energy harvesters utilizing vortex-induced vibrations (VIV) have been extensively studied for converting wind energy into usable power for microelectronics. In this work, we explore the use of structural bistability to increase the range of flow speeds over which energy can be harvested without the need for complicated assemblies. We propose a harvester system featuring a piezoelectric transducer bonded to a cantilevered bistable composite laminate, which has two distinct equilibrium shapes at room temperature. To enhance the VIV, we attach a cylindrical bluff body to the free edge of the harvester. The structure’s inherent bistability allows for high power generation at two different flow speeds, contrasting with the single synchronization region typical of linear piezoelectric harvesters. We develop a reduced-order model to predict power output across varying flow speeds and validate these predictions through wind tunnel experiments, showing good agreement. Furthermore, we conduct a parametric study to optimize the model parameters for maximum power output. Our results demonstrate that the bistable harvester can generate up to 4.5 mW of power over a wind speed range of 9.3 m s−1–11.7 m s−1, outperforming the limited speed range of traditional linear VIV-based harvesters. This work underscores the potential to design VIV-based energy harvesters capable of operating efficiently across multiple flow speed ranges using a single structure with its dual stable configurations.
18 June 2024 in Composite Structures
25 September 2025 in Composite Structures