We investigate the development of wormholes in laboratory‐scale fractures using three‐dimensional numerical simulations. Well‐controlled initial conditions, involving a small perturbation near the inlet of an otherwise flat fracture aperture field, were used to make a systematic study of the effects of flow rate and reaction rate on the aperture evolution. We find at least two characteristic wormhole shapes, which can be grouped within a phase diagram in the space of Péclet and Damköhler numbers. We investigate how this phase diagram depends on fracture geometry, specifically the length (L) and width (W) in comparison to the initial aperture (h0). This information is used to determine an effective Damköhler number that leads to a Péclet and length‐independent phase boundary between wormholes and uniform dissolution. We relate these observations to experimental studies of wormhole formation in dissolving fractures.
22 September 2023 in Environmental Science & Technology
It has been proposed to use magnesium oxide (MgO) to separate carbon dioxide directly from the atmosphere at the gigaton level. We show experimental results on MgO single crystals reacting with the atmosphere for longer (decades) and shorter (days to months) periods with the goal of gauging reaction rates. Here, we find a substantial slowdown of an initially fast reaction as a result of mineral armoring by reaction products (surface passivation). In short-term experiments, we observe fast hydroxylation, carbonation, and formation of amorphous hydrated magnesium carbonate at early stages, leading to the formation of crystalline hydrated Mg carbonates. The preferential location of Mg carbonates along the atomic steps on the crystal surface of MgO indicates the importance of the reactive site density for carbonation kinetics. The analysis of 27-year-old single-crystal MgO samples demonstrates that the thickness of the reacted layer is limited to ∼1.5 μm on average, which is thinner than expected and indicates surface passivation. Thus, if MgO is to be employed for direct air capture of CO2, surface passivation must be circumvented.