So far, the inspection of power line corridors is mainly carried out by manual or helicopters. However, manual inspection is very labour-intensive and inefficient. On the other hand, the cost of the inspection using helicopters is very high. Also the safety of helicopters cannot be guaranteed. In recent years, some researchers have started to use unmanned helicopters to inspect power lines. Nevertheless, their focuses are the development of autonomous control systems. In this paper, we present an applied inspection robotic system based on an unmanned autonomous helicopter (UAH) for power line corridor inspection. Our interest is on the combination of the autonomous helicopter and the inspection system for the practical application in the field. This paper describes the whole architecture of the robotic system and presents some design issues. The experimental results are presented as well.
Cutting force prediction is very important to optimize machining parameters and monitor machining state. In order to predict cutting force of sculptured surface machining with ball end mill accurately, tool posture, cutting edge, contact state between cutter, and workpiece are studied. Firstly, an instantaneous motion model of ball end mill for sculptured surface is established. The instantaneous milling coordinate system and instantaneous tool coordinate system are defined to describe the position and orientation of tool, and the transformation matrix between coordinate systems is derived. Secondly, by solving three boundaries around engagement of cutter and workpiece, a cutter-workpiece engagement model related to tool posture, milling parameters, and tool path is established. It has good adaptability to the variable tool axis relative to the machining surface. Finally, an algorithm of thickness about an instantaneous undeformed chip is researched, and a prediction model of cutting force is realized with microelement cutting theory. Also, the model is suitable for sculptured surface machining with arbitrary tool posture and feed direction. The accuracy of the proposed prediction model was verified by a series of experiments.
Based on the high hardness, poor thermal conductivity, and easy detachment of graphite in cast iron materials. Traditional rough machining inserts cannot achieve good machining surface quality, while the use of precision machining inserts results in rapid tool wear due to excessively sharp rake angles, limiting feed rates and reducing machining efficiency. In order to solve these problems, this paper proposes a method of cutting cast iron with coarse and wiper insert mixed cutting tools, aiming to improve the surface quality of machining and enhance machining efficiency. By studying the mechanism and cutting experiments of the wiper inserts, it was found that it improved the surface quality of cast iron and analyzed the reasons for tool wear. By controlling the integrity of the precision machined surface of cast iron, the aim is to establish the basic theory and key technologies for the precise and efficient manufacturing of high hardness materials. Improve the surface quality of cast iron processing, extend tool life, and improve processing efficiency.