The radiation characteristics of a dipole antenna when immersed in both fresh and seawater are assessed through simulation and experimental work. Simulations show that the antenna's bandwidth and radiation pattern change with the properties of the medium where it is placed, namely the conductivity of the medium. Two dipoles antennas with current baluns were built and tested experimentally in freshwater. The tests included the measurement of the insertion loss between two identical dipole antennas and their radiation pattern. The results obtained show a good agreement between the simulation and experimental results.
In this paper we assess the influence of the conductivity of the medium on the radiation characteristics and input impedance of a loop antenna designed for underwater communications. The initial study is based on simulation of the antenna characteristics using FEKO electromagnetic (EM) software. Additionally, an equivalent circuit model of the antenna is also obtained and simulation of the input impedance on ADS software shows good agreement with the EM simulator. It is found that the radiation pattern, of the loop antenna changes significantly with the conductivity of the medium, from freshwater to seawater. The loop antennas were built with baluns and tested in freshwater, where the insertion loss between two identical antennas and the radiation pattern of one of them were also measured. The results show good agreement with the simulations.
The capability of relatively high-speed short-range communications of Autonomous Underwater Vehicles (AUVs) in underwater scenarios, for example, for communication between vehicles or when the AUV is approaching a docking station for downloading of data gathered during a survey mission, is becoming a relevant application in the context of sea exploration and mining. In this paper the analysis of the J-pole antenna and two of its configurations namely Super J-pole and Collinear J-pole antennas are presented, aimed at improving the propagation distance and data rates when such antennas are installed on AUV for onward usage in underwater communications. The performance of these three antennas is assessed through simulation in fresh and sea water, operating in the High Frequency (HF) band. These antennas are compared in terms of bandwidth and directivity which are important elements in the transmission and reception of electromagnetic signals. The results obtained show that these antennas will be desirable both for improved data rates and propagation distance in fresh and sea water. The antennas were designed with FEKO electromagnetic simulation software.
The propagation of RF signals is affected by rain and there are traditional models that allow the determination of a fade margin, to ensure operationality in periods of precipitation. Nowadays, this fact has been exploited in reverse to determine the amount of precipitation, using commercial radio links. Electromagnetic wave propagation models show that the attenuation by rain begins to have a significant impact for frequencies above 10 GHz. However, in some systems operating at 2.4 GHz there is packet loss when it is raining. So, a 2.4 GHz outdoor wireless sensor network was set up to study the influence of meteorological parameters in the received signal. Our results show a significant impact on link quality when it is raining. We also observed that temperature affects the link's quality, exhibiting a daily cycle, improving communications when the temperature is cooler.
Correct measurement of precipitation over a wide area is important for accurate predictions of flash floods or for water resource management. Today, the three main rainfall monitoring systems are rain gauges, weather radars and satellites. However, they all have limitations such as spatial resolution, mountain blockade and price, respectively. A new approach uses commercial telecommunications links to monitor precipitation. However, there are places where the density of commercial connections is low or they belong to private companies, which makes it difficult to obtain the data. In this work is presented a low-cost, in-house built 24 GHz link to study the influence of weather in signal quality. Preliminary results are presented, which show that there is a direct relation with temperature and that it is possible to detect precipitation.