We performed H-cell and flow cell experiments to study the electrochemical reduction of CO2 to oxalic acid (OA) on a lead (Pb) cathode in various nonaqueous solvents. The effects of anolyte, catholyte, supporting electrolyte, temperature, water content, and cathode potential on the Faraday efficiency (FE), current density (CD), and product concentration were investigated. We show that a high FE for OA can be achieved (up to 90%) at a cathode potential of -2.5 V vs Ag/AgCl but at relatively low CDs (10-20 mA/cm2). The FE of OA decreases significantly with increasing water content of the catholyte, which causes byproduct formation (e.g., formate, glycolic acid, and glyoxylic acid). A process design and techno-economic evaluation of the electrochemical conversion of CO2 to OA is presented. The results show that the electrochemical route for OA production can compete with the fossil-fuel based route for the base case scenario (CD of 100 mA/cm2, OA FE of 80%, cell voltage of 4 V, electrolyzer CAPEX of $20000/m2, electricity price of $30/MWh, and OA price of $1000/ton). A sensitivity analysis shows that the market price of OA has a huge influence on the economics. A market price of at least $700/ton is required to have a positive net present value and a payback time of less than 10 years. The performance and economics of the process can be further improved by increasing the CD and FE of OA by using gas diffusion electrodes and eliminating water from the cathode, lowering the cell voltage by increasing the conductivity of the electrolyte solutions, and developing better OA separation methods.
26 March 2019 in Industrial & Engineering Chemistry Research
Recently, deep eutectic solvents (DES) have been considered as possible electrolytes for the electrochemical reduction of CO2 to value-added products such as formic and oxalic acids. The applicability of pure DES as electrolytes is hindered by high viscosities. Mixtures of DES with organic solvents can be a promising way of designing superior electrolytes by exploiting the advantages of each solvent type. In this study, densities, viscosities, diffusivities, and ionic conductivities of mixed solvents comprising DES (i.e., reline and ethaline), methanol, and propylene carbonate were computed using molecular simulations. To provide a quantitative assessment of the affinity and mass transport of CO2 and oxalic and formic acids in the mixed solvents, the solubilities and self-diffusivities of these solutes were also computed. Our results show that the addition of DES to the organic solvents enhances the solubilities of oxalic and formic acids, while the solubility of CO2 in the ethaline-containing mixtures are in the same order of magnitude with the respective pure organic components. A monotonic increase in the densities and viscosities of the mixed solvents is observed as the mole fraction of DES in the mixture increases, with the exception of the density of ethaline-propylene carbonate which shows the opposite behavior due to the high viscosity of the pure organic component. The self-diffusivities of all species in the mixtures significantly decrease as the mole fraction of DES approaches unity. Similarly, the self-diffusivities of the dissolved CO2 and the oxalic and formic acids also decrease by at least 1 order of magnitude as the composition of the mixture shifts from the pure organic component to pure DES. The computed ionic conductivities of all mixed solvents show a maximum value for mole fractions of DES in the range from 0.2 to 0.6 and decrease as more DES is added to the mixtures. Since for most mixtures studied here no prior experimental measurements exist, our findings can serve as a first data set based on which further investigation of DES-containing electrolyte solutions can be performed for the electrochemical reduction of CO2 to useful chemicals.
Carbon dioxide (CO2) is currently considered as a waste material due to its negative impact on the environment. However, it is possible to create value from CO2 by capturing and utilizing it as a building block for commodity chemicals. Electrochemical conversion of CO2 has excellent potential for reducing greenhouse gas emissions and reaching zero net emissions by 2050. To date, Carbon Capture and Utilization (CCU) technologies have been studied independently. We report a novel methodology based on the integration of CO2 capture and conversion by the direct utilization of a CO2 capture media as electrolyte for electrochemical CO2 conversion. This has a high potential for reducing capital and operational cost when compared to traditional methodologies. A novel mixture of chemical and physical absorption solvents allowed for the captured CO2 to be converted to formic acid with faradaic efficiencies up to 50 % and with carbon conversion of ca. 30 %. By increasing the temperature in the electrochemical reactor from 20 °C to 75 °C, the productivity towards formic acid increased by a factor of 10, reaching up to 0.7 mmol∙m-2·s-1. The direct conversion of captured CO2 was also demonstrated for carbon monoxide formation with faradaic efficiencies up 45 %.