Yao Lu

Yao Lu

Auto-generated profile, based on publicly available information

Yao Lu

Fiber and Polymer Science Program, Department of Textile Engineering, Chemistry and Science, North Carolina State University, Raleigh, NC 27695-8301, USA

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 April 2016 in Nanomaterials
Verified
Journal Article
Open access
PDF file
SSSarah L. Stanley
Sarah L. Stanley
FSFrank Scholle
Frank Scholle
JZJiadeng Zhu
Jiadeng Zhu
YLYao Lu
Yao Lu
Xiangwu ZhangXiangwu Zhang
Xiangwu Zhang
RGReza Ghiladi
Reza Ghiladi
Toward the objective of developing platform technologies for anti-infective materials based upon photodynamic inactivation, we employed electrospinning to prepare a non-woven textile comprised of polyacrylonitrile nanofibers embedded with a porphyrin-based cationic photosensitizer; termed PAN-Por(+). Photosensitizer loading was determined to be 34.8 nmol/mg material; with thermostability to 300 °C. Antibacterial efficacy was evaluated against four bacteria belonging to the ESKAPE family of pathogens (Staphylococcus aureus; vancomycin-resistant Enterococcus faecium; Acinetobacter baumannii; and Klebsiella pneumonia), as well as Escherichia coli. Our results demonstrated broad photodynamic inactivation of all bacterial strains studied upon illumination (30 min; 65 ± 5 mW/cm2; 400–700 nm) by a minimum of 99.9996+% (5.8 log units) regardless of taxonomic classification. PAN-Por(+) also inactivated human adenovirus-5 (~99.8% reduction in PFU/mL) and vesicular stomatitis virus (>7 log units reduction in PFU/mL). When compared to cellulose-based materials employing this same photosensitizer; the higher levels of photodynamic inactivation achieved here with PAN-Por(+) are likely due to the combined effects of higher photosensitizer loading and a greater surface area imparted by the use of nanofibers. These results demonstrate the potential of photosensitizer-embedded polyacrylonitrile nanofibers to serve as scalable scaffolds for anti-infective or self-sterilizing materials against both bacteria and viruses when employing a photodynamic inactivation mode of action.

20 November 2015 in Sensors
Verified
Journal Article
Open access
PDF file
DLDawei Li
Dawei Li
PLPengfei Lv
Pengfei Lv
JZJiadeng Zhu
Jiadeng Zhu
YLYao Lu
Yao Lu
CCChen Chen
Chen Chen
QWQufu Wei
Qufu Wei
NiCu alloy nanoparticle-loaded carbon nanofibers (NiCuCNFs) were fabricated by a combination of electrospinning and carbonization methods. A series of characterizations, including SEM, TEM and XRD, were employed to study the NiCuCNFs. The as-prepared NiCuCNFs were then mixed with laccase (Lac) and Nafion to form a novel biosensor. NiCuCNFs successfully achieved the direct electron transfer of Lac. Cyclic voltammetry and linear sweep voltammetry were used to study the electrochemical properties of the biosensor. The finally prepared biosensor showed favorable electrocatalytic effects toward hydroquinone. The detection limit was 90 nM (S/N = 3), the sensitivity was 1.5 µA µM−1, the detection linear range was 4 × 10−7–2.37 × 10−6 M. In addition, this biosensor exhibited satisfactory repeatability, reproducibility, anti-interference properties and stability. Besides, the sensor achieved the detection of hydroquinone in lake water.

2 July 2015
Verified
Book Chapter
Closed access
PDF file
YLYao Lu
Yao Lu
CCChen Chen
Chen Chen
Xiangwu ZhangXiangwu Zhang
Xiangwu Zhang

4 February 2015
Verified
Book Chapter
Closed access
PDF file
YLYao Lu
Yao Lu
CCChen Chen
Chen Chen
Xiangwu ZhangXiangwu Zhang
Xiangwu Zhang