13 February 2024 in IEEE Transactions on Applied Superconductivity
We investigate here the feasibility of operating a three-phase diode rectifier at cryogenic temperature. To do so, several power diodes are tested at room and LN2 temperatures. Then a 3.4 kW three-phase diode rectifier prototype is built and tested at room and LN2 temperatures. Besides we prove that one can predict the performances of such cryogenic diode rectifier by using only the measured diode I-V characteristics. Finally, we assess the relevance of this technology by comparing a cryogenic diode rectifier with its conventional counterpart. The gain may not be in terms of efficiency if cooling power has to be generated, but in terms of power density, since the heat sink is greatly reduced when considering LN2 operation. This study is of interest for compact and lightweight superconducting conversion chains in various sectors, including wind energy and air transportation.
26 February 2026 in IEEE Transactions on Applied Superconductivity
This work investigates the feasibility of a superconducting DC railway traction substation in which the conventional transformer, diode rectifier, and copper cables are replaced by a partially superconducting transformer, a cryogenic diode rectifier, and superconducting cables. A 3 kW prototype DC traction substation was designed, assembled and experimentally characterized. System performance, encompassing electrical efficiency (i.e., not including the cooling penalty), was evaluated, providing insights into the behavior of each superconducting component compared with its conventional counterpart. The transformer employs a copper primary winding at room temperature and a high temperature superconducting secondary winding operating at 77 K, eliminating the need for bulky terminations. The proposed design successfully operated and exhibited higher efficiency compared to its conventional equivalent. The cryogenic diode rectifier, based on selected commercial diodes, demonstrated higher efficiency than the room-temperature version on a large operating range. The high temperature superconducting cables operated without any measurable losses under rectified load current conditions. Overall, the results confirm that the superconducting system operated as intended, suggesting possible gains in compactness and electrical efficiency compared to conventional DC traction substations.
1 January 2026 in IET Electric Power Applications
The development of power electronic converters operating at cryogenic temperatures is limited by the lack of data on electronic components outside the standard temperature range specified by manufacturers (typically above −65°C, i.e., 208 K). To fill this gap, the construction of an open access database of power electronic component characteristics at cryogenic temperatures is presented. As a first step, the focus is on the electrical characterisation of power diodes at both room (293 K) and liquid nitrogen (77 K) temperatures. We present a tailored experimental protocol that allows their I–V characteristics to be obtained in a reproducible manner at both temperatures. Additionally, we share the results obtained for more than 60 power diodes, having nominal current from a few amperes to several thousand amperes. We also analyse the variability among same‐reference diodes and the impact of repeated thermal cycling on a given diode. Finally, we demonstrate the practical usefulness of such database through a case study. We predict the performance (losses, efficiency) of a 1 kW single‐phase diode rectifier at 77 K using only the I–V characteristics of the diode from the database, and we show that it matches the performance experimentally measured on the corresponding prototype.
1 August 2026 in IEEE Transactions on Applied Superconductivity