Javier Rodriguez-Fernandez

Javier Rodriguez-Fernandez

Auto-generated profile, based on publicly available information

Javier Rodriguez-Fernandez

Wireless Networking and Communications Group, The University of Texas at Austin, Austin, TX, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 March 2018 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
JRJavier Rodriguez-Fernandez
Javier Rodriguez-Fernandez
NGNuria Gonzalez-Prelcic
Nuria Gonzalez-Prelcic
KVKiran Venugopal
Kiran Venugopal
RHRobert Heath
Robert Heath
Channel estimation is useful in millimeter wave (mmWave) MIMO communication systems. Channel state information allows optimized designs of precoders and combiners under different metrics such as mutual information or signal-to-interference- noise (SINR) ratio. At mmWave, MIMO precoders and combiners are usually hybrid, since this architecture provides a means to trade-off power consumption and achievable rate. Channel estimation is challenging when using these architectures, however, since there is no direct access to the outputs of the different antenna elements in the array. The MIMO channel can only be observed through the analog combining network, which acts as a compression stage of the received signal. Most of prior work on channel estimation for hybrid architectures assumes a frequency-flat mmWave channel model. In this paper, we consider a frequency-selective mmWave channel and propose compressed-sensing- based strategies to estimate the channel in the frequency domain.We evaluate different algorithms and compute their complexity to expose trade-offs in complexity-overhead-performance as compared to those of previous approaches.

23 March 2018 in IEEE Journal of Selected Topics in Signal Processing
Verified
Journal Article
Closed access
JGJosé P. González-Coma
José P. González-Coma
JRJavier Rodriguez-Fernandez
Javier Rodriguez-Fernandez
NGNuria Gonzalez-Prelcic
Nuria Gonzalez-Prelcic
Luis CastedoLuis Castedo
Luis Castedo
RHRobert Heath
Robert Heath
Configuring the hybrid precoders and combiners in a millimeter wave multiuser multiple-input multiple-output system is challenging in frequency selective channels. In this paper, we develop a system that uses compressive estimation on the uplink to configure precoders and combiners for the downlink. In the first step, the base station (BS) simultaneously estimates the channels from all the mobile stations on each subcarrier. To reduce the number of measurements required, compressed sensing techniques are developed that exploit common support on the different subcarriers. In the second step, exploiting reciprocity and the channel estimates the BS designs hybrid precoders and combiners. Two algorithms are developed for this purpose, with different performance and complexity tradeoffs: First, a factorization of the purely digital solution; and second, an iterative hybrid design. Extensive numerical experiments evaluate the proposed solutions comparing to the state-of-the-art strategies, and illustrating design tradeoffs in overhead, complexity, and performance.

26 July 2021 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
JRJavier Rodriguez-Fernandez
Javier Rodriguez-Fernandez
Synchronization is a fundamental procedure in cellular systems whereby user equipment (UE) acquires the time and frequency information required to decode the data transmitted by a base station (BS). Due to the small antenna aperture at millimeter wave (mmWave), large antenna arrays are used to compensate for the low signal-to-noise ratio (SNR) at the receiver. For this reason, synchronization is often performed jointly with beam training as in 5G New Radio (NR) to boost the receive SNR. However, if the mmWave multiple-input multiple-output (MIMO) channel is to be estimated, then synchronization must be performed in the low SNR regime owing to the lack of directional beamforming during compressive channel estimation. Current mmWave channel estimation algorithms implicitly take synchronization for granted, which is a not practical assumption in the low SNR regime. To solve this problem, this work proposes the first synchronization framework for hybrid mmWave MIMO that is robust to carrier frequency offset (CFO) and phase noise (PHN) synchronization errors. We propose two novel multi-stage algorithms to jointly estimate the various unknown parameters, based on the expectation-maximization (EM) algorithm. By using the QuaDRiGa 5G NR channel simulator, we show that compressive channel estimation without prior synchronization is possible, and the proposed approaches outperform current solutions for joint beam training and synchronization currently considered in 5G NR.

26 June 2019 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
JRJavier Javier Rodriguez-Fernandez
Javier Javier Rodriguez-Fernandez
NGNuria Gonzalez-Prelcic
Nuria Gonzalez-Prelcic
Channel estimation at millimeter wave (mmWave) allows designing hybrid precoders and combiners to optimize performance metrics such as the spectral efficiency. One major source of difficulty when estimating the high-dimensional and large-bandwidth channel, however, is the Carrier Frequency Offset (CFO) that impairs the received signal. Most of prior work assume perfect time-frequency synchronization when estimating the channel. In practical systems, however, this assumption does not hold, and joint time-frequency synchronization is an important issue to deal with. In this paper, we propose a multi-stage algorithm for joint CFO and channel estimation. Using a training protocol between transmitter and receiver, we estimate first the equivalent low-SNR beamformed channel and the CFO, using the Maximum-Likelihood (ML) criterion. Thereafter, using these estimates, the high-dimensional Multiple-Input Multiple-Output (MIMO) channel is estimated leveraging its angular sparsity. Simulation results show that, using our proposed strategy, small estimation errors and near-optimal values of spectral efficiency can be achieved, without incurring in significant overhead and/or computational complexity.