Mode-locked lasers (MLLs) generate ultrashort pulses with peak powers substantially exceeding their average powers. However, integrated MLLs that drive ultrafast nanophotonic circuits have remained elusive because of their typically low peak powers, lack of controllability, and challenges when integrating with nanophotonic platforms. In this work, we demonstrate an electrically pumped actively MLL in nanophotonic lithium niobate based on its hybrid integration with a III-V semiconductor optical amplifier. Our MLL generates4.8-ps optical pulses around 1065 nm at a repetition rate of ∼10 GHz, with energies exceeding 2.6 pJ and peak powers beyond 0.5 W. The repetition rate and the carrier-envelope offset frequency of the output can be controlled in a wide range by using the driving frequency and the pump current, providing a route for fully stabilized on-chip frequency combs.
Photonics offers unique capabilities for quantum information processing (QIP) such as room‐temperature operation, the scalability of nanophotonics, and access to ultrabroad bandwidths and consequently ultrafast operation. Ultrashort pulse sources of quantum states in nanophotonics are an important building block for achieving scalable ultrafast QIP; however, their demonstrations so far have been sparse. Here, we demonstrate a femtosecond biphoton source in dispersion‐engineered periodically poled lithium niobate nanophotonics. We measure 17 THz of bandwidth for the source centered at 2.09 µm, corresponding to a few optical cycles, with a brightness of 8.8 GHz/mW. Our results open new paths toward realization of ultrafast nanophotonic QIP.
Quantum key distribution allows for a provably secure transmission of cryptographic keys over an optical channel. Encoded polarization states or time-bin degree of freedom have been used for successful demonstrations. However, photon losses in long fibers, slow single photon detectors, and detector dark counts significantly limit the overall bit rate. Improving key throughput and reducing the overhead of key reconciliation remain as major challenges. Methods which utilize multiple time bins allow for multiple key bits to be encoded in a single photon, thus increasing the fidelity of transmitted keys and decreasing the overhead of key reconciliation in real-world conditions. Previous implementations of these methods required that Alice and Bob share a time reference by sharing a dedicated classical channel used for synchronization. This work presents a technique that allows two parties to exchange time-bin encoded photons without the need for synchronized time references. Our technique uses a framing protocol which allows Alice to encode a time reference along with a key which is determined by Alice before transmission. Security can be achieved by monitoring the visibility of a pair of Franson interferometers, using decoy pulses and measuring the round trip time between Alice and Bob. The bit rate of this technique is limited only by the recovery time of the detector and the speed of the modulation electronics. We experimentally demonstrate a raw bit rate of 5Mb/s over an optical channel with 55dB of loss, which is competitive with current research. We also demonstrate absolute timing synchronization with an accuracy of 20ps.
Squeezed vacuum, a fundamental resource for continuous-variable quantum information processing, has been used to demonstrate quantum advantages in sensing, communication, and computation. While most experiments use homodyne detection to characterize squeezing and are therefore limited to electronic bandwidths, recent experiments have shown optical parametric amplification (OPA) to be a viable measurement strategy. Here, we realize OPA-based quantum state tomography in integrated photonics and demonstrate the generation and all-optical Wigner tomography of squeezed vacuum in a nanophotonic circuit. We employ dispersion engineering to enable the distortion-free propagation of femtosecond pulses and achieve ultrabroad operation bandwidths, effectively lifting the speed restrictions imposed by traditional electronics on quantum measurements with a theoretical maximum clock speed of 6.5 THz. We implement our circuit on thin-film lithium niobate, a platform compatible with a wide variety of active and passive photonic components. Our results chart a course for realizing all-optical ultrafast quantum information processing in an integrated room-temperature platform.
This paper highlights micro-transfer printing (MTP) as a promising scalable approach to heterogeneous integration for silicon photonics. MTP uniquely achieves high integration density, high throughput, and high material efficiency through a low-temperature, back-end integration process. Current demonstrations, including integrated III-V lasers and thin-film electro-optic modulators, confirm MTP's potential. Industrial adoption requires resolving challenges related to final integration yield and throughput, device reliability, and supply chain maturity.