The demand for food and pharmaceutical packaging materials is increasing, but the most common materials used are non-renewable, non-biodegradable petroleum-based plastics, which has resulted in many end-of-life problems. Cellulose nanocrystals (CNCs) and chitin nanowhiskers (ChNWs) have high strength and low oxygen permeability (OP), providing a renewable alternative. In this work, we spray coated ChNWs and CNCs on cellulose acetate (CA) film and tuned the film properties by adjusting the spray coating temperature (Tspray) and the post thermal treatment temperature (Tthermal). Importantly, by increasing Tspray (from 40 to 100 °C) and Tthermal (from 40 to 140 °C), the OP decreased 48% and 62%, respectively. The optimal OP (i.e., 11.5 cm3 μm m−2 day−1 kPa−1) is comparable to that of commercial oriented poly(ethylene terephthalate). Film transmittance and haze were dependent on both temperatures, with higher Tspray and Tthermal giving rise to coated films with lower haze and higher transmittance values approaching those of bare CA. The mechanical properties and water vapor barrier properties of the coated films were on average 20% and 11% enhanced compared to neat CA, without being significantly influenced by the temperatures. These properties support the use of the polysaccharide-based film as a renewable substitute in packaging applications.
In this work, we examine ways to advance sustainability in material packaging by applying scalable, dual‐layer coating techniques for generating thin biopolymer barrier films on paper substrates. Unbleached kraft paper and supercalendered glassine paper are used as substrates, and cellulose nanocrystals (CNC) and chitosan (CS) are used for coatings. CNC and CS are applied on the substrates using single‐layer (multi‐pass) or dual‐layer slot die coating on a roll‐to‐roll (R2R), with similar grammage coated under the same conditions. The effect of CNC suspension pH is also examined. Coated papers are characterized to determine oxygen permeability (OP) and water vapor transmission rate (WVTR) at 50% and 80% RH as well as mechanical properties. Single‐layer multi‐pass coated paper exhibits improved OP and WVTR compared to coated kraft paper. Glassine paper coated with a coat weight of 20.6 ± 1.0 g/m 2 of CNC at a suspension pH of 3 has the lowest OP value of 3.9 ± 1.0 cm 3 ·µm/m 2 /d/kPa. The use of dual‐layer slot die coating produces similar OP values at a large coat weight as single‐layer multi‐pass coating. We demonstrate the viability of scalable fabrication of multilayer renewable bioproducts for packaging by using processes amenable to sequential or simultaneous coating on a R2R.