Cold rolling emulsion contains a variety of functional additives, which often exhibit complex interactions with each other. Sodium alkane sulfonate (SAS) is a common corrosion inhibitor used in cold rolling emulsions for temporary rust prevention. In this study, it was found that SAS would deteriorate the tribological properties of the emulsion. Emulsions containing SAS and different friction modifiers were prepared. Tribology tests were carried out on a four-ball friction and wear tester. White light interferometer was used to investigate the 3D morphology of the friction surface and wear volume. Microscopic morphology of friction surfaces was observed using a scanning electron microscope (SEM). The chemical activity and electrostatic potential of the molecules were calculated based on density functional theory (DFT). The adsorption energies of additives on metal surfaces were calculated via molecular dynamics (MD) simulation. The results indicate that the strong electrostatic force gives SAS an advantage in competitive adsorption with ester friction modifiers due to the positive charge on the metal surface. This results in the friction modifier not functioning properly and the tribological properties of the emulsion being significantly reduced.
1 April 2022 in Journal of Physics and Chemistry of Solids
LiCoO 2 is still the potential first choice of cathode for lithium ion batteries due to the superior tap density of 4.1 g cm −3 and high theoretical specific capacity of 274 mAh g −1 . However, the reversible capacity and cycle performance are restricted due to structural instability at high voltage (≥4.5 V). In this work, the problem will be improved by multiple synergistic effect of nano-Ag. The flake-like LiCoO 2 /Ag cathodes are firstly synthesized by solid state reaction and the following calcination. The structural characteristics reveal that Ag nanoparticles with ca. 10 nm are uniformly embedded into LiCoO 2 particles. The initial discharge specific capacity of LiCoO 2 is increased by 12% by introducing nano-Ag at 100 mA g −1 (∼0.7C) between 3.0–4.5 V, and after 100 cycles, the discharge specific capacity is enhanced by 52%. Furthermore, when the current density is increased to 2000 mA g −1 , the specific capacity retention of LiCoO 2 /Ag researches to 62%, higher than 52% of LiCoO 2 . The results clearly indicate that LiCoO 2 /Ag cathode exhibits excellent specific capacities, enhanced cycle stability and rate performances enabled by nano-Ag through enhancing Li ions diffusion, electron transport and improving structural stability.