15 May 2019 in Journal of Lightwave Technology
In this paper, we propose and demonstrate a gas pressure fiber probe with high sensitivity which is amplified by Vernier effect. The probe is composed of two cascaded FPIs based on a SMF-SOHST-OFC structure (FPI: Fabry-Perot interferometer; SMF: Single mode fiber; SOHST: side opened hollow silica tube; OFC: optical fiber column). The high-frequency CO2 laser drilling method for HST (HST: hollow silica tube) can effectively maintain the transient balance of air pressure inside and outside of the cavity without destroying the reflective ends of the optical fibers. Experimental results show that the prepared fiber probe with the SOHST length of 375.2μm and the OFC length of 247.3μm has a high gas pressure sensitivity of 80.3pm/kPa by demodulating Vernier envelope, and a relative low temperature cross-sensitivity of -1.33kPa/°C. This sensor is highly sensitive and of compact size, which not only can be applied in gas pressure sensing, but also has potential for microfluidic detection.
16 July 2021 in Journal of Lightwave Technology
A novel method based on deep learning technique for the modal decomposition of the optical fields emerging from the few-mode fiber is demonstrated in this paper. By combining the advantages of principal component analysis (PCA) and Back-Propagation (BP) neural network, this scheme can reveal the exact superposition of eigenmodes. Firstly, PCA algorithm is applied to preprocess the target samples to reduce the computational complexity and extract the characteristics of the samples. Then, the mapping between the mode coefficients and the preprocessed near-field beam patterns is learned by using the BP neural network. The superiority of the proposed scheme is evaluated through simulation and experiment. The results show that the scheme can perform a complete modal decomposition within a few milliseconds, and it can still work well when the SNR level is as low as 20 dB. It is also worth noting that the method described in this work also has the advantages of short network training time, non-iterative, and low experimental equipment requirements.
1 January 2020 in Optical Fiber Technology
1 October 2021 in Optics & Laser Technology
13 February 2018 in IEEE Sensors Journal
A novel arch-shaped long-period fiber grating (ALPFG) is proposed and fabricated by a high-frequency CO 2 laser on a single-mode fiber. The ALPFG is composed of a string of arch grids, which can provide stronger refractive index modulation than normal planar grids. The asymmetrical structure induced by arch grid and one-side exposure allows it to sense vector bending in two orthogonal directions. Within the curvature range from 0.5 to 2.2 m -1 , its bending sensitivities can reach 22.120 and -18.626 nm/m -1 for the two opposite directions. Its temperature recycle and force characteristics are also provided.
8 November 2021 in IEEE Sensors Journal
A novel two-parameter fiber sensor has been demonstrated, consisting of D-shaped composite fiber gratings (DCFG) which includes long period fiber grating (LPFG) and fiber Bragg grating (FBG) inscribed on D-shaped fiber. LPFG is inscribed on the side of D-shaped fiber by a high-frequency CO 2 laser. On account of the asymmetry of the structure in 90° and 270° and refractive index modulation (RIM) in 0° and 180°, the sensor can recognize the bending directions. In the theory, it is proved that by adjusting the thickness of D-shaped fiber, the bending sensitivity can be enhanced in 90° and 270° directions. In the experiments, the fiber sensor achieves the sensitivity of curvature up to 13.70 nm/m −1 , which is nearly two times as the similar structure without D-shaped fiber. The curvature and temperature sensitivities of LPFG and FBG are different in DCFG, so the proposed sensor can realize simultaneously measurement of curvature vector and temperature.