12 August 2022 in Journal of Materials Chemistry C
A novel combination method for nitrogen doping and 3D structure construction is explored to prepare nitrogen-doped Ti3C2Tx aerogels. The synergistic effects of nitrogen doping and 3D structure construction on Ti3C2Tx are analyzed.
22 May 2023 in ACS Applied Nano Materials
12 June 2023 in Semiconductor Science and Technology
In this paper, a new push–pull pFLASH switch is designed and fabricated based on a 110 nm eFLASH process, which includes two 2 T-pFLASH transistors and one signal transmission transistor. The pFLASH transistors are programmed and erased by band-to-band tunneling-induced hot electron and Fowler–Nordheim tunneling to realize its ‘on/off’ function, and the current of the signal transmission transistor can be effectively tuned by the drain voltage of the 2 T-pFLASH. In order to clarify the degradation mechanism of the electronic properties, first principles calculations are performed from the atomic scale. Nitrogen vacancies have been proven to play a crucial role in nitrides. In addition, the effects of vacancies on the charge retention are investigated in terms of electronic structure. The nitrogen vacancies have proven to be detrimental to the electron storage by the simulated localization energies. Therefore, this study will provide a newly designed field-programmable gate array configuration unit, whose electrical mechanisms are revealed by theoretical simulations, which can also become the design foundation for future FLASH switches.
1 January 2022 in SSRN Electronic Journal
Constructing 3D porous MXene from 2D nanosheets is the most efficient method to avoid restacking of nanosheets and enhance the application of nanomaterials at macroscale. Direct foaming from solids is an ideal means to obtain 3D porous strcucture. However, MXene is difficult to be physically foamed because its plasticity is not enough. Herein, we invent a chemical foaming method to convert MXene films into foams with good porosity. The wet film of Ti3C2T x precursor with interlayer water has super high plasticity, which is more conducive to the introduction of foaming agent and the foaming process. The obtained Ti3C2T x foams exhibits good porosity and higher specific surface area than Ti3C2T x films, resulting in outstanding capacitive performance (491 F g-1 at 2 mV s-1) with good rate performance (70 F g-1 at 1000 mV s-1) and excellent cycle stability (92% retention after 10000 cycles). Moreover, the foaming method creates a up-bottom construction patterns, which is simple, low cost and easy for scalable fabricating porous MXene.