Herein, inspired by previous reports on the electrochemical reduction of Al in diverse electrolyte systems, we describe a novel Al-containing solvate ionic liquid (2:1 (mol/mol) mixture of ethylene carbonate (EC) and AlCl3) that allows low-temperature electrochemical deposition of Al and features the advantages of low cost, ease of preparation, and high electrochemical stability. Electrodeposition of Al-Li alloy and Li can also be realized in this system. Additionally, the above ionic liquid exhibited a saturated vapor pressure of 0.0012 kPa and a conductivity of 1.32 mS/cm at 298 K, which was acceptable for practical applications. To elucidate the electrochemical deposition mechanism, the ionic components of the 2:1 EC/AlCl3 system were characterized by a range of instrumental analysis techniques and theoretical calculations, and Lewis-acidic cations were identified as the electroactive species for Al electrodeposition. Notably, an Al-Li alloy could be obtained by co-deposition in the new solvate ionic liquid, and Li metal could also be electrodeposited on a high-purity Al plate in the form of Al4Li9 and Li3Al2 under ambient conditions using LiCl as a Li source. Al-containing solvate ionic liquids, which to an extent evolved from organic-salts, are of increasing interest. They are expected to gain more attention in the field of electrochemical metallurgy of active metals, due to their higher tunability and lower price.
8 April 2019 in Journal of the Electrochemical Society
The design of electrolyte systems suitable for room-temperature electrochemical extraction of Li, Mg, Al, Ti, rare earth elements, and other active metals from their salts or oxides has long been a scientific challenge. Herein, we report an exceptional organic solvent (1,3-dimethyl-2-imidazolidinone) supported by LiNO3 with properties superior to those of conventional ionic liquids and show that it is well suited for room-temperature potentiostatic deposition of La coatings from LaCl3 on high-purity Al substrates. Thus, this work paves the way to cost-effective La extraction and presents an innovative approach to the selection of electrolyte systems used for electrodeposition of active metals.
15 September 2021 in The Journal of Physical Chemistry C
Fine Cu powder was prepared by a solid−liquid plasma discharge electrolysis process using a CuSO4 - H2SO4 solution. The X-ray diffraction results indicated the presence of Cu2O impurity in the obtained Cu powder. The Cu content in the powder increased with increase in the concentration of CuSO4, and pure ultra-fine Cu powder was obtained using 0.2 M CuSO4 - 0.2 M H2SO4 solution. Emission spectrum analyses indicated that a large number of hydrogen radicals (H⋅) generated in solution contained H2SO4 during the process of plasma discharge was the reason for the formation of pure Cu, therefore the formation mechanism of Cu could be described by the whole reaction Cu2+ + 2H⋅ → Cu + 2H+, and the formation of impurity Cu2O was caused by the reaction of Cu2(OH)22++ 2e− → Cu2O + H2O in electrolyte. The formation process of Cu and Cu2O in two types of solution were described in detail. Scanning electron microscopy analyses indicated that Cu2O particles were polyhedron-shaped with an average diameter of 100–200 nm.