29 October 2021 in Science
Measuring the effective charge: At low enough temperatures, superconductors are capable of conducting electricity without any resistance because of the formation of so-called Cooper pairs of electrons. Cooper pairs typically form at the same critical temperature at which superconductivity sets in. In certain materials, they are thought to form above that temperature, but showing this property directly in an experiment is tricky. Bastiaans et al . used tunneling noise spectroscopy to measure the effective charge of current carriers in the disordered superconductor titanium nitride. As expected, below the critical temperature, the effective charge was equal to two electron charges. However, this behavior persisted above the critical temperature, indicating that electron pairs exist in that regime. —JS
5 August 2019 in Nature Astronomy
19 July 2016 in Physical Review Letters
We describe theoretically the depairing effect of a microwave field on diffusive -wave superconductors. The ground state of the superconductor is altered qualitatively in analogy to the depairing due to a dc current. In contrast to dc depairing, the density of states acquires, for microwaves with frequency , steps at multiples of the photon energy and shows an exponential-like tail in the subgap regime. We show that this ac depairing explains the measured frequency shift of a superconducting resonator with microwave power at low temperatures.
21 June 2019 in Journal of Astronomical Telescopes, Instruments, and Systems
Cool gas is the most abundant phase of matter in the interstellar medium of galaxies and in the Earth’s atmosphere. Hence, precise knowledge of the spatial variation and dynamics of the physical and chemical properties of cool gas is of crucial importance for astrophysics,1 as well as weather forecasting and global climate modeling.2,3 These properties can be diagnosed using passive terahertz remote sensing, because many molecules and atoms in cool gas make energy level transitions that leave distinct fingerprints in the terahertz emission spectrum.4 However, most of the currently used coherent receivers5 can observe only about 1 to 10 GHz of bandwidth at a time (exceptionally up to 6,7). This makes it very time consuming to cover a significant fraction of the 0.1- to 1-THz band (referred to as “terahertz radiation” in the remainder of this article), where the atmosphere is partially transparent. Indeed, it is often essential to probe multiple energy transitions of multiple chemical species to make a meaningful diagnosis, calling for much wider simultaneous bandwidths.2,8
27 October 2017 in IEEE Transactions on Terahertz Science and Technology
Superconducting hot-electron bolometers are presently the best performing mixing devices for the frequency range beyond 1.2 THz, where good-quality superconductor-insulator-superconductor devices do not exist. Their physical appearance is very simple: an antenna consisting of a normal metal, sometimes a normal-metal-superconductor bilayer, connected to a thin film of a narrow short superconductor with a high resistivity in the normal state. The device is brought into an optimal operating regime by applying a dc current and a certain amount of local-oscillator power. Despite this technological simplicity, its operation has found to be controlled by many different aspects of superconductivity, all occurring simultaneously. A core ingredient is the understanding that there are two sources of resistance in a superconductor: a charge-conversion resistance occurring at a normal-metal-superconductor interface and a resistance due to time-dependent changes of the superconducting phase. The latter is responsible for the actual mixing process in a nonuniform superconducting environment set up by the bias conditions and the geometry. The present understanding indicates that further improvement needs to be found in the use of other materials with a faster energy relaxation rate. Meanwhile, several empirical parameters have become physically meaningful indicators of the devices, which will facilitate the technological developments.
21 January 2012 in Journal of Low Temperature Physics
We present measurements of quasiparticle generation-recombination noise in aluminium Microwave Kinetic Inductance Detectors, the fundamental noise source for these detectors. Both the quasiparticle lifetime and the number of quasiparticles can be determined from the noise spectra. The number of quasiparticles saturates to 10 μm−3 at temperatures below 160 mK, which is shown to limit the quasiparticle lifetime to 4 ms. These numbers lead to a generation-recombination noise limited noise equivalent power (NEP) of 1.5×10−19 W/Hz1/2. Since NEP∝N qp , lowering the number of remnant quasiparticles will be crucial to improve the sensitivity of these detectors. We show that the readout power now limits the number of quasiparticles and thereby the sensitivity.