Ben Silvester

Ben Silvester

Auto-generated profile, based on publicly available information

Ben Silvester

Warwick Manufacturing Group (WMG), University of Warwick, Coventry, U.K

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2022 in Journal of Magnetism and Magnetic Materials
Verified
Journal Article
Open access
FWFanfu Wu
Fanfu Wu
LZLEI ZHOU
LEI ZHOU
JSJuliette Soulard
Juliette Soulard
BSBen Silvester
Ben Silvester
CDClaire Davis
Claire Davis

19 May 2023 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
JSJuliette Soulard
Juliette Soulard
XMX. Y. Ma
X. Y. Ma
EGE. Griffin
E. Griffin
BSB. Silvester
B. Silvester
Prediction of iron loss in electrical machines is known to be a challenging task. The concept of a building factor to account for discrepancy between predicted and measured loss is widely used. From literature, these building factors may need to be as high as 1.5 to 2, i.e., a discrepancy of up to 100%, leading to different impact on total losses for every electrical machine. To calibrate the building factor, modelling and testing are required. This paper describes an extensive test campaign on PM synchronous machines at no-load with magnetized and dummy rotors. Several challenges to accurately quantify no-load iron loss by dynamic testing for model calibration are reported, highlighting the benefits of rotor temperatures monitoring, and performing repeatability checks. For accurate prediction of iron loss impacted by mechanical stress (due to cut edge damage or shrink-fit for example), advanced modelling approaches require electrical steel properties (BH and loss density) as function of tensile and compressive stress. Such measurements with a dedicated single sheet tester have not yet been standardized. Repeatability issues and spread of measured data are presented and their influence mitigated by a pre-cycling procedure. A novel method to compare the impact of stress on several electrical steel grades including thicknesses from 0.1 mm to 0.35 mm indicates different grades follow similar trends. However, the changes are grade-specific, requiring characterization of each material grade at multiple stress level, frequency, and flux density for advanced modelling of e-machine performance.