1 February 2020 in International Journal of Hydrogen Energy
1 August 2010 in Applied Thermal Engineering
1 March 2013 in Journal of Renewable and Sustainable Energy
Neem oil methyl ester (NOME) was prepared from neem oil using alkaline catalyzed transesterification. The important fuel properties of NOME, 20% blend of NOME with diesel, were compared with those of diesel. Optimum injection pressures were determined for neat diesel and NOME-20 blend. Comparison of brake specific fuel consumption (BSFC), brake thermal efficiency (BTE), exhaust gas temperature (EGT), and smoke density was done for diesel and NOME-20 blend at their respective optimum injection pressure. Higher BSFC, a slight decrease in BTE, and a sharp decrease in EGT and smoke density were recorded with NOME-20 blend. Emissions with NOME-20 blend were also compared with diesel emissions at their respective optimum injection pressures. Significant reductions in carbon monoxide, hydrocarbon, and oxides of nitrogen and increase in carbon-di-oxide were observed with NOME-20 blend. Hence, neem biodiesel has an environmental importance over diesel and shows a promising future.
18 June 2013 in Journal of Energy
Distributed generation (DG) of electricity is expected to become more important in the future electricity generation system. This paper reviews the different technological options available for DG. DG offers a number of potential benefits. The ability to use the waste heat from fuel-operated DG, known as combined heat and power (CHP), offers both reduced costs and significant reductions of CO2emissions. The overall efficiency of DG-CHP system can approach 90 percent, a significant improvement over the 30 to 35 percent electric grid efficiency and 50 to 90 percent industrial boiler efficiency when separate production is used. The costs of generation of electricity from six key DG-CHP technologies; gas engines, diesel engines, biodiesel CI engines, microturbines, gas turbines, and fuel cells, are calculated. The cost of generation is dependent on the load factor and the discount rate. It is found that annualized life cycle cost (ALCC) of the DG-CHP technologies is approximately half that of the DG technologies without CHP. Considering the ALCC of different DG-CHP technologies, the gas I.C. engine CHP is the most effective for most of the cases but biodiesel CI engine CHP seems to be a promising DG-CHP technology in near future for Rajasthan state due to renewable nature of the fuel.
1 July 2017 in Journal of Renewable and Sustainable Energy
Conventional energy sources are limited, whereas the energy demand is increasing exponentially. There is immediate need to develop efficient systems to extract more useful energy from the same fuel input. Cogeneration and trigeneration systems use waste heat from prime movers to produce more useful energy than conventional methods in the form of heat and cooling. In this paper, an experimental and simulation based study of compression ignition engine operated micro-cogeneration and trigeneration systems working on diesel and other vegetable oil based fuel derivatives is presented. The energy and exergy analyses of both the cogeneration and trigeneration systems were done. The results obtained with base line diesel show that the overall thermal efficiency was 79.43% for cogeneration and 78.64% for trigeneration. The exergy efficiency of the system was found to be 32.80% for cogeneration and 33.08% for trigeneration. The system was modeled and simulated using TRNSYS, and the simulation results were compared with the experimental results for the validation. The improved system model for trigeneration was developed using TRNSYS to determine the scope for improvement, and it was found that it achieved the energy efficiency of 89.20% and the exergy efficiency of 45.94%.