Besides temperature at one atmosphere, the applied pressure is another important parameter for influencing and controlling reaction pathways and final reaction products. This is relevant not only for the genesis of natural minerals, but also for synthetic chemical products and technological materials. The present critical review (316 references) highlights recent developments that utilise high pressures and high-temperatures for the synthesis of new materials with unique properties, such as high hardness, or interesting magnetic or optoelectronic features. Novel metal nitrides, oxonitrides as well as the new class of nitride-diazenide compounds, all formed under high-pressure conditions, are highlighted. Pure oxides and carbides are not considered here. Moreover, syntheses under high-pressure conditions require special equipment and preparation techniques, completely different from those used for conventional synthetic approaches at ambient pressure. Therefore, we also summarize the high-pressure techniques used for the synthesis of new materials on a laboratory scale. In particular, our attention is focused on reactive gas pressure devices with pressures between 1.2 and 600 MPa, multi-anvil apparatus at P < 25 GPa and the diamond anvil cell, which allows work at pressures of 100 GPa and higher. For example, some of these techniques have been successfully upgraded to an industrial scale for the synthesis of diamond and cubic boron nitride.
The melting curves of two compositions of (Mg,Fe)SiO 3 -perovskite, the likely dominant mineral phase in the lower mantle, have been measured in a CO 2 laser-heated diamond cell with direct temperature measurements and in situ detection of melting. At 625 kilobars, the melting temperature is 5000 ± 200 kelvin, independent of composition. Extrapolation to the core-mantle boundary pressure of 1.35 megabar with three different melting relations yields melting temperatures between 7000 and 8500 kelvin. Thus, the temperature at the base of the lower mantle, accepted to lie between 2550 and 2750 kelvin, is only at about one-third of the melting temperature. The large difference between mantle temperature and corresponding melting temperature has several important implications; particularly the temperature sensitivity of the viscosity is reduced thus allowing large lateral temperature variations inferred from seismic tomographic velocity anomalies and systematics found in measured velocity-density functions. Extensive melting of the lower mantle can be ruled out throughout the history of the Earth.
The solidus of a pyrolite-like composition, approximating that of the lower mantle, was measured up to 59 gigapascals by using CO 2 laser heating in a diamond anvil cell. The solidus temperatures are at least 700 kelvin below the melting temperatures of magnesiowüstite, which in the deep mantle has the lowest melting temperatures of the three major components—magnesiowüstite, Mg-Si-perovskite, and Ca-Si-perovskite. The solidus in the deep mantle is more than 1500 kelvin above the average present-day geotherm, but at the core-mantle boundary it is near the core temperature. Thus, partial melting of the mantle is possible at the core-mantle boundary.