In this article, the temperature-dependent complex Hall effect near the magnetization compensation temperature of CoGd alloy films is systematically studied. We find anomalies of Hall loops with characteristics similar to the topological Hall effect (THE), which is usually considered to indicate the occurrence of topological spin texture. However, the THE is ruled out by detailed magnetic and transport measurements on CoGd alloy films with different composition ratios. After considering the influence of the spin-flop effect and the inhomogeneity of the components naturally formed in the ferrimagnetic CoGd alloy, we constructed a phenomenological model that can explain the complex Hall effect near the magnetization compensation point without relying on the THE. The main result is helpful for explaining the microscopic magnetic properties and transport properties of rare-earth transition metal ferrimagnetic alloys near the compensation point.
Back-hopping type soft errors and etching-induced shunting failure are among the primary failure mechanisms preventing spin-orbit torque magnetic random access memory (SOT-MRAM) technology from commercialization. In this work, a novel writing scheme is proposed, which effectively suppresses back-hopping type soft failures, achieving a writing error rate below 1 ppm and a significantly widened write margin for enhanced reliability. Meanwhile, by inserting a buffer layer between the free layer and the SOT layer, we demonstrated significantly reduced shunting failure, yield improvement, and a raw bit error rate down to 52 ppm on 300 mm wafers. Additionally, a high-yield magnetic tunnel junction with a tunnel magnetoresistance (TMR) of 134% is demonstrated through material and stack optimization. These progresses pave the way for the development of high-density SOT-MRAM chips with Mbit~Gbit capacities.
17 December 2025 in IEEE Transactions on Electron Devices
To enhance device yield and performance of magnetic tunnel junctions (MTJs) for spin-orbit-torque magnetic random access memory (SOT-MRAM) with standard architecture, several ion beam etching (IBE) processes have been developed and systematically compared. The introduction of a silicon nitride (SiN) protection layer prior to the grazing-angle IBE step enables simultaneous reduction of footing effects and efficient removal of metal redeposition. This approach results in high uniform devices and a breakthrough yield exceeding 99.9% on 300-mm wafers. Further optimization of the grazing etch process enhances the process window, enabling robust devices with tight electrical and magnetic parameter distributions. Our innovative etch process paves the way for the high-yield mass production of SOT-MRAM.